Need help?Do you have a question about the Bosch FPA-5000 and is the answer not in the manual?
General| Max Number of Detectors per Loop | 254 |
|---|---|
| Display | LCD |
| Network Capability | Yes |
| Power Supply | 24 V DC |
| Operating Temperature | -5°C to +50°C |
| Communication Ports | Ethernet |
| Humidity Range | 95% non-condensing |
Instructions for operating the touch-sensitive display.
Procedures for cleaning and maintaining the touch screen and surfaces.
Information on how the panel controller operates and its compliance with standards.
Specifies the qualifications needed for operating and configuring the system.
Description of fixed keys and their functions for panel operation.
Further details on status LED meanings and combinations.
Cautions and advice for operating and maintaining the touch-sensitive display.
Step-by-step instructions for powering the panel on, off, and rebooting.
Procedures for the first-time setup, including touch screen calibration and date/time settings.
How to log into and out of the panel controller using user credentials.
Detailed steps for logging onto the panel with user ID and password.
Procedure to log off from the panel controller.
Configuration of network IP settings for Ethernet connectivity.
Information on network diagnostics tools and services.
How to operate and interpret the display of a remote keypad.
Steps to establish a connection between a remote keypad and a panel.
Procedure to safely disconnect from a remote panel.
Classification of different alarm types recognized by the panel controller.
How entry delays are used to prevent false alarms.
Process of investigating and confirming alarms to ensure they are genuine.
How the system handles alarms differently based on day or night mode settings.
How alarm messages are presented on the panel, including signals and displays.
How to manually control evacuation zones and start/stop evacuations.
Explains the process of fire alarm verification and investigation time.
Details on the time allocated for investigating a fire alarm.
Steps to bypass detectors that have triggered an alarm.
How to access and view fault messages on the panel.
Overview of fault messages displayed on the panel.
Steps to block an element that has caused a fault.
How to bypass and un-bypass individual elements in the system.
Steps to un-bypass the output for fault warning routing equipment.
Procedures for blocking and unblocking system elements.
How to view detailed diagnostic information for LSN modules and elements.
How to access diagnostic information for specific modules.
Information related to hardware diagnostics, including LED and display tests.
Performing LED tests and display tests for hardware verification.
Information about performing walktests on system elements.
How to organize elements into groups for walktesting.
How to start and end a walktest for selected elements or groups.
Step-by-step guide to initiating a walktest.
Procedures for ending a walktest for a specific group.
How to end the walktest for all groups and elements.
Detailed steps for switching modes via menu or status bar.
Information and procedures for using the master password.
Procedures for resetting elements to their initial state.
Instructions for entering and using the panel's boot menu for advanced functions.
To Next Page
