70 en | Maintenance – history log
FPA-5000 | FPA-1200 | AVENAR panel 8000 |
AVENAR panel 2000 | AVENAR keypad 8000
2020-07 | 3.0 | F.01U.378.877 User Guide Bosch Sicherheitssysteme GmbH
16.3 Change Filter
On each filter menu, another filter can be set using the status bar:
1. Select Change filter from the selection bar below.
The various filters are displayed.
2. Select one of the filters displayed.
A list with filtered data is displayed.
16.4 Combining several filters
It is possible to set several filters and to display all filtered data in a list:
To combine the Device types filter with the Message types filter:
1. Select Maintenance from the start menu
2. History Log
3. Select a filter, e.g. Device types.
4. Select Change filter in the selection list.
5. Select the desired device types from the displayed list.
6. Repeat steps 4 to 5 until all desired filters have been selected.
To display all filtered data of the combined filters:
7. Select Show filter result.
16.5 Status bar functions
The following functions are offered:
To switch to the status bar on the start page, press the "double
arrow" key in the status bar or on the membrane keypad.
Change filter If the field has a black background, a filter has been set. Select
this field to set a different filter.
Go to no. Enter the number of a specific event.
The event with the selected number is displayed at the start of
the list.
Go to day Enter a date.
All events with the selected date are displayed in the list.
Print Print the complete displayed list or only a part of it.
Exit End the entry and switch to the menu overview for the
Maintenance menu.
16.6 Printing out data
Either the complete list or a specific part of it can be printed out.
To print out data that is displayed on a list:
1. Select Print from the status bar.
Two possibilities are offered:
– Entire list: The complete list is selected.
To print the list, continue with step 6.
– Define range: Specify a particular area within the list.
The following two possibilities are available to specify the area of the list to be printed
out:
– Limit the number of events, counted from the newest event.
– Specifying a particular area via the entry of the event numbers.
To Next Page
Loading...
