22 en | Operating principle
FPA-5000 | FPA-1200 | AVENAR panel 8000 |
AVENAR panel 2000 | AVENAR keypad 8000
2020-07 | 3.0 | F.01U.378.877 User Guide Bosch Sicherheitssysteme GmbH
5.3 Logging on and off
To gain access to access levels 2 to 4, it is necessary to log on. The prerequisite is that you
have access authorization.
Notice!
To log on, you need a user ID and password. Depending on your access authorization, you can
use only particular functions.
In the following cases, you will be asked to enter a password:
You are not logged on and want to select a function for which a password is required.
You are already logged on but a higher access authorization is required for the function you
have selected.
5.3.1 Logging on
To log on to the panel controller:
Press the login key .
The login window is displayed:
1. Enter your user ID in the first field.
Refer to
Entering numbers and text, page 27
for information on how to enter numbers.
2. Enter your password in the second field.
Notice!
The default password is: 000000. For security reasons please change this password, see
Change password, page 83
.
3. Select OK to confirm the entries or Cancel to cancel the operation.
Refer to
Change password, page 83
for information on how to set up your own
password.
The standby display is shown.
As long as an operator is logged on, the key icon will be displayed on the information bar.
In addition, the user ID of the user who has logged on is displayed on the start page on the
information bar.
Notice!
In the FSP-5000-RPS programming software, a time span can be specified after which an
operator who is logged on to the panel controller is logged off.
5.3.2 Logging off
1. To log off from the panel controller, press :
An input window with the request Log off? is displayed:
2. Select Yes to confirm the request or No to cancel the operation.
5.4 Access authorization
Notice!
Depending on your access authorization, you can only use certain functions of the panel
controller.
To Next Page
Loading...
