FPA-5000 | FPA-1200 | AVENAR panel 8000 |
AVENAR panel 2000 | AVENAR keypad 8000
Fire alarm | en 41
Bosch Sicherheitssysteme GmbH User Guide 2020-07 | 3.0 | F.01U.378.877
– Fuchsia: Groups which are actively being controlled without a real alarm, e.g. in case of a
fire drill
– Green: Groups which are not active
– Yellow: Groups in fault or disabled, no control is possible.
9.2 Optical and acoustic signals
– The alarm LED and the evacuation LED light up red
– An internal buzzer sounds; see also
Silence internal buzzer, page 41
.
– Depending on the configuration, sounders and/or visual notification appliances (e.g.
sirens, strobes) are activated.
If the transmission device to the fire department is activated, the LED icon lights up red:
9.3 Acknowledging a message
There are two ways to acknowledge messages:
– Select Acknowledge. Only those alarm messages which are visible in the display are
acknowledged.
– Select a message and then press Acknowledge. Only the selected message is
acknowledged.
Notice!
If Go to Acknowledge is displayed, select this field in order to display the messages that have
not yet been acknowledged.
9.4 Silence internal buzzer
Press the following key to temporarily silence the internal buzzer:
The internal signal tone is silenced.
9.5 Activate and silence signaling devices
Sounders and optical signaling devices which have been activated can be switched off.
4 Select Signals off.
The sounder and/or optical signaling device is switched off.
Notice!
On the next alarm message, all signaling devices that have been switched off are switched
back on automatically.
4 To switch the notification appliance back on, select Signals on.
The signaling devices are switched on again.
9.6 Resetting signaling devices and transmission devices
4 To reset control or transmission devices, select Control in the status bar
Notice!
The display automatically changes back to alarm indication after 30 seconds. To return to the
alarm indication before 30 seconds have elapsed, select Fire.
To Next Page
Loading...
