Bosch FPA-5000 - Remote Services; Remote connection; Remote Maintenance; Remote Alert

82 en | Further functions
FPA-5000 | FPA-1200 | AVENAR panel 8000 |
AVENAR panel 2000 | AVENAR keypad 8000
2020-07 | 3.0 | F.01U.378.877 User Guide Bosch Sicherheitssysteme GmbH
The panel controller generates a number on request. Please forward this number to the after
sales support department by telephone or e-mail. A password which is only valid for 24 hours
will be provided.
1. In the start menu, select Further functions
2. Master password
3. Create number
4. Request password
A number is displayed.
5. Give the number issued by the system to the Support department.
6. Once you have received the 24-hour password from the Support department, select Enter
password!.
7. Enter the password.
The 24-hour master password is accepted and the user is logged on.
Change password
To change passwords, select Change password.
Additional options may be offered.
19.4 Remote Services
Remote connection
Notice!
If another menu is called up while the remote connection is still active, Teleservice Active is
displayed. To blank out the text, touch the screen. The text re-appears every 30 seconds for
as long as the remote connection remains active.
To create a remote connection via telephone:
– In the start menu, select Further functions
– Remote access
– Enable call
The system can now be called from remote. Afterwards, the connection is disconnected.
– Active is displayed when a connection has been made.
To disconnect the connection, select Stop remote access .
Remote Maintenance
To stop the data transmission of Remote Maintenance:
– In the start menu, select Further functions
– Remote Services
– Select Block Remote Maintenance.
The transmission of data to the Remote Portal is stopped until the next restart of the
panel controller.
– To unblock the service select Unblock Remote Maintenance.
Notice!
The Blocking/Unblocking of Remote Maintenanceis done for all panels in the network. You
cannot block/unblock this service for a single panel.
Remote Alert
To stop the transmission of Remote Alert messages:
– In the start menu, select Further functions
– Remote Services
– Select BlockRemote Alert.