Bosch FPA-5000 - Maintenance; Walktest

FPA-5000 | FPA-1200 | AVENAR panel 8000 |
AVENAR panel 2000 | AVENAR keypad 8000
Maintenance | en 63
Bosch Sicherheitssysteme GmbH User Guide 2020-07 | 3.0 | F.01U.378.877
14 Maintenance
This chapter contains information about the following points:
– Walktest: see Maintenance – walktest, page 65
– Change language, page 63
– Activate Outputs, page 63
– Activate Transmission Device, page 64
– Detector removal
– History Log: see Maintenance – history log, page 69
– Bypassing/Un-bypassing buzzer, page 64
14.1 Menu overview
Maintenance -> Walktest Change language
Activate outputs Activate transmission device
History log Bypass buzzer
14.2 Change language
Notice!
The fastest way to change the language display is via a shortcut; see also Changing language
display, page 28 .
There are two ways of selecting a different language display:
– Using the menu
– Entering a shortcut; see Changing language display, page 28 .
Notice!
After the system starts up following a power cut or battery failure, the default language
defined in the FSP-5000-RPS programming software is set again.
Making a selection via the menu
1. In the start menu, select Maintenance
2. Change language
A list of the languages which can be selected is displayed.
3. Select the language you require.
The displays are displayed in the selected language.
14.3 Activate Outputs
1. In the start menu, select Maintenance
2. Activate outputs
Various element categories are displayed.
3. Select a category or Select by number and enter the number of the element into the
search screen; see also Search Function/Element, page 26
4. Select the required list fields. The list fields are marked.
5. Select On to activate the selected notification appliances.
The selected signaling devices are activated.
6. Select All to activate all notification appliances.
7. To end activation of the selected elements, repeat the same steps but select Off in step
5.