Bosch FPA-5000 - Operator; Change universal password; Set Default Password

78 en | Configuration
FPA-5000 | FPA-1200 | AVENAR panel 8000 |
AVENAR panel 2000 | AVENAR keypad 8000
2020-07 | 3.0 | F.01U.378.877 User Guide Bosch Sicherheitssysteme GmbH
Notice!
The password must contain at least three digits.
18.5.1 Change password
1. In the start menu, select Configuration
2. Operator
3. Change operator data
A list of all operators is displayed.
4. Select the list field you require.
5. Enter a new password. Repeat the new password in the bottom field again.
On the display, each digit of the password is indicated with an asterisk so that nobody
else can see the password.
6. Select OK to confirm the entry or Cancel to cancel the operation.
The entry is confirmed.
18.5.2 Change universal password
1. In the start menu, select Configuration
2. Operator
3. Change universal password
4. Depending on the access level for which the password is to be changed, select the list
field you require.
5. Enter a new password and repeat the entry in the bottom field again.
On the display, each digit of the password is indicated with an asterisk so that nobody
else can see the password.
6. Select OK to confirm the entry or Cancel to cancel the operation.
The entry is confirmed.
18.5.3 Set Default Password
1. In the start menu, select Configuration
2. Operator
3. Set default password
A list of all operators is displayed.
4. Select the list field you require.
The list field is marked.
5. Select Reset.
The operator’s password is reset to his/her previous password.
18.6 Rename elements
To change the name of an element:
1. In the start menu, select Configuration
2. Rename elements
A list of all elements is displayed.
3. Select the list field you require.
An entry screen is displayed.
4. Enter a new name.
5. Select OK to confirm the entry or Cancel to cancel the operation.
The event with the new name is displayed on the list.