Bosch 430 Series Release Notes

Product
Document type
Release #
SAP/Doc number
DVR 400 Series
Release notes
V2.1.1
Security Systemsystems
Release date
2013.11.08
Page 4 of 6
3.2 Version 1.6.0
File name: 400series.bin (2011-11-15)
This release includes the following improvement:
• Setting added to Auto delete video older than 3 days. For some countries this is required
by law.
• SMTP port number was default on 587 when SSL is enabled.
o This port number is now user selectable.
This release includes the following bug fixes were below issues are solved:
• In low or unstable network configurations the DVR sometimes block any network user
access until the unit was power cycled.
• It was not possible to record a tour in G3 domes via DVR.
• DVR was losing network gateway in some network applications.
• Network connection was not possible immediately after network disconnect.
• DVR ID in web pages showed one number higher than set in DVR.
• DVR rebooted after a number of smart search actions in web interface.
3.3 Version 1.5.0
File name: 400series.bin (2011-03-28)
This release includes the following improvement:
- PC application support (CC v3.32) of DVR 400 Series with firmware version 1.5.0.
3.4 Version 1.4.0
File name: 400series.bin (2011-01-25)
This release includes the following improvements:
1. Added RTSP server to be able to stream video over RSTP to make it possible to show live
video on Smart Phones.
You can connect to the DVR 400 to view one live-view channel as follows:
1. Enable RTSP On in Network-TCP/IP menu for DVR 400.
2. Set the DVR IP address in DHCP or enable static IP for DVR 400.
3. Input the following on the smart phone.
– rtsp://xxx.xxx.xxx.xxx/cgi-bin/rtspStream/1
4. If the RTSP port is not the default port (554), use the following on the smart phone.
– rtsp://xxx.xxx.xxx.xxx:firewall open port/cgi-bin/rtspStream/1
Note: xxx.xxx.xxx.xxx is the DVR IP address; 1 refers to channel 1, 2 refers to channel 2, etc.
2. System rights for “Normal users” in the system can be extended per user for playback,
search, export and alarm acknowledge.
3. Per default the HDD is not anymore divided in a normal and event or partition. HDD can
record event and normal recordings. Still an event partition can be programmed if required.

Bosch 430 Series Specifications

General

Video Compression	H.264
Audio Compression	G.711
Power Supply	12 VDC
Motion Detection	Yes
Network Interface	Ethernet
Operating Temperature	-10°C to +55°C
Remote Viewing	Yes
Number of Channels	4
Series	430
Channels	4