How to start Bosch Lawn Mower?
If your Bosch Lawn Mower fails to operate, it might be due to a few reasons. First, the isolator key may not be correctly or fully inserted; ensure it's properly fitted. Also, make sure to hold the On/Off switch for 1 – 3 seconds to start the motor.
Why does my Bosch Rotak 430 LI Lawn Mower motor start and stop immediately?
If the Bosch Lawn Mower motor starts and stops immediately, it could be related to the battery. Ensure the battery is fully charged. Also, check that the battery is correctly inserted. Another potential issue is the isolator key not being fully inserted; make sure it is correctly fitted. The battery might also be too hot or too cold; allow it to cool or warm up as needed. As a final measure, try increasing the height of cut.
What to do if my Bosch Rotak 430 LI Lawn Mower is not charging?
If the Bosch Lawn Mower is not charging, the battery contacts might be contaminated. You can clean them by reinserting the battery several times or consider replacing the battery.
Why Bosch Rotak 430 LI won't start?
If your Bosch Lawn Mower fails to operate, a possible cause is the grass being too long. Increase the height of cut and tilt the lawn mower to reduce the starting load. Also, the motor protector may have activated; allow the motor to cool and increase the height of cut. The battery might also be too hot or cold; allow it to cool or warm. Also, there may be clogging; remove the isolator key and check underneath the lawn mower, clearing out any debris. Always wear protective gloves when clearing debris.
What to do if my Bosch Lawn Mower functions intermittently?
If your Bosch Lawn Mower is functioning intermittently, the motor protector might have activated. Allow the motor to cool and increase the height of cut.
How to fix ragged finish with Bosch Lawn Mower?
If the Bosch Lawn Mower leaves a ragged finish, it might be because the height of cut is too low; increase it. Another reason could be a blunt cutting blade; replace it. Also, check for possible clogging underneath the lawn mower and clear it out as necessary, always wearing protective gloves.
Why is the cutting blade not rotating on my Bosch Rotak 430 LI?
If the Bosch Lawn Mower cutting blade is not rotating while the product is switched on, switch off the lawn mower. A possible cause is that the cutting blade is obstructed. Clear any obstruction, always wearing protective gloves. Additionally, check if the blade nut/bolt is loose and tighten it to 17 Nm.
Why is my Bosch Rotak 430 LI motor labouring?
If the Bosch Lawn Mower motor is labouring, it could be due to several factors related to the grass. If the height of cut is too low, increase it and walk slower. If the grass is too high, increase the height of cut and walk slower. If the grass is wet or damp, wait until it is dry and walk slower. If the grass is dense, increase the height of cut, walk slower, and cut more frequently.
Why is my Bosch Lawn Mower making excessive vibrations/noise?
If you are experiencing excessive vibrations or noise with your Bosch Lawn Mower, it could be due to a loose blade nut/bolt; tighten it to 17 Nm. Another possible cause is a damaged cutting blade; replace it.
What to do if the charge control LEDs don't light up on my Bosch Lawn Mower?
If the charge control LEDs do not light up after inserting the mains plug into the socket for your Bosch Lawn Mower, ensure the mains plug of the battery charger is fully inserted into the socket outlet.
Essential safety precautions, operational advice, and proper disposal methods.
Instructions for safe operation, handling, and understanding product safety symbols.
Detailed safety recommendations for operating the lawnmower.
Instructions for using the leaf collection feature and performing product maintenance.
Advice on how to best handle and care for the battery.
Important safety precautions and advice for handling lithium-ion batteries.
Specifications and technical details for the lawnmower models.
Information on noise/vibration, mounting, starting, and charging.
Detailed steps for charging, indicators, temperature, and troubleshooting.
Operational tips, battery life factors, and cutting conditions.
Solutions for common operational problems encountered with the lawnmower.
Procedures for product maintenance and information for after-sales service.
Official statement confirming the product meets EU directives and standards.
Detailed technical data, including noise levels, for Rotak 370 LI and 430 LI.
General| Power source | Battery |
|---|---|
| Battery voltage | 36 V |
| Battery life (max) | 70 min |
| Cordless | Yes |
| Type | Push lawn mower |
| Cooling type | Air |
| Cutting width | 430 mm |
| Product color | Black, Green |
| Uncertainty K | 1.5 m/s² |
| Cutting height | 20 - 70 mm |
| Cutting system | - |
| Sound power level | 90 dB |
| Standard deviation | 1 dB |
| Vibration emission | 2.5 m/s² |
| Sound pressure level | 76 dB |
| Recommended lawn area | 600 m² |
| Maximum cutting height | 70 mm |
| Minimum cutting height | 20 mm |
| Grass collecting volume | 50 L |
| Cutting clearance adjustment | 6 |
Weight and Dimensions| Weight | 13800 g |
|---|
To Next Page