Why Bosch Mower cutting blade is not rotating?
If the cutting blade of your Bosch Mower is not rotating while the product is switched on, switch off the mower first. There might be an obstruction, so clear it, always wearing protective gloves. Also, check if the blade nut or bolt is loose and tighten it to 17 Nm.
Why my Bosch Mower fails to operate?
If your Bosch Mower isn't operating, there might be a few reasons. First, check for any clogging underneath the mower and clear it out, wearing protective gloves. Another reason may be that the grass is too long, so increase the cutting height and tilt the mower to reduce the load. It's also possible the motor protector has activated, so allow the motor to cool and increase the cutting height. Other potential issues could be that the battery isn't fully charged or properly inserted, the battery is too hot or cold, or the isolator key isn't correctly fitted.
What to do if Bosch Mower motor starts and stops immediately?
If your Bosch Mower motor starts and stops immediately, several factors could be at play. Ensure the battery is fully charged and correctly inserted. Also, check that the isolator key is properly fitted. The battery might also be too hot or too cold. If these aren't the issue, try increasing the height of cut.
Why area of cut of Bosch Mower is not large enough?
If the area cut by your Bosch Mower isn't large enough, it could be due to several reasons. Try increasing the height of cut and walking slower. If the grass is too high, wet, damp, or dense, these could also be factors. Increase the height of cut, walk slower, and cut more frequently in dense grass. You can also purchase an additional battery from an authorized customer service agent for Bosch garden products.
How to fix Bosch Mower that leaves ragged finish?
If your Bosch Mower is leaving a ragged finish, it might be because the height of cut is too low. Try increasing the height of cut. Alternatively, the cutting blade might be blunt, in which case you should replace it.
What to do if charge control LEDs of Bosch Mower do not light up?
If the charge control LEDs of your Bosch Mower do not light up after inserting the mains plug into the socket, make sure the mains plug of the battery charger is fully inserted into the socket outlet. If the issue persists, the socket outlet, mains cable, or battery charger might be defective. Check the mains voltage and, if necessary, have the battery charger checked by an authorized customer service station for Bosch power tools.
Why Bosch Mower motor labours?
If your Bosch Mower motor is labouring, it could be due to a possible clogging. Check underneath the mower and clear out any obstructions as necessary, always wear protective gloves. Another cause might be the blade fitted upside down, refit blade correctly.
Why is no charging procedure possible for Bosch Mower?
If no charging procedure is possible for your Bosch Mower, the battery contacts might be contaminated. Clean the battery contacts by inserting and removing the battery several times, or consider replacing the battery. Also, if the battery is defective due to a disconnection in the battery (individual cells), replace it.
Why Bosch Mower functions intermittently?
If your Bosch Mower functions intermittently, it may be due to damaged internal wiring. In this case, contact a service agent. Also, the motor protector might have activated; allow the motor to cool and increase the height of cut.
General| Brand | Bosch |
|---|---|
| Model | Rotak 43 LI Ergoflex |
| Category | Lawn Mower |
| Language | English |
To Next Page