H
55
NTC Removal
Now, from inside the dishwasher remove the
Lower Spray Arm, Filter Basket and Screen, then
remove the two screws that attach the Feeder
Tube to the Sump, item 1. And the two Sump
Clamps, item 2.
With the block in place you now have the required
access to replace the NTC.
Service note: The Circulation Pump / Motor can
also be replaced at this time, see
Section 8.
With all steps complete, bring the Tank up from
the Base and insert a block in the rear of the unit
between the Tank and the Base.
1
2
Fig. 14-10
Fig. 14-9
Fig. 14-8
To Next Page
Loading...
