H
63
Base Components
Fig. 16-1
4
3
2
1
The Tank can now be removed from the Base.
Service note: Once removed, lay the Tank on its back so as not to damage the tank bottom. When re-
seating the Tank make sure to check that it’s inserted squarely back into the Sump and
seated properly.
With the Tank removed you now have access to the following components:
1. Circulation Motor
2. Circulation Pump
3. Heater Assembly
4. Aqua Sensor
Service reminder: As previously mentioned in Section 7, the Circulation Pump / Motor can also be
replaced from the right side without removing the Tank. However, the additional
visibility and access the Tank removal method allows can be a greater benefit for
this repair.
To Next Page
Loading...
