English - 9
1 • F016 L70 495 • TMS • 19.12.06
The following table gives checks and actions that you can perform if your machine does not operate correctly.
If these do not identify/remedy the problem, contact your service agent.
Warning: Switch off and remove plug from mains before investigating fault.
Fault Finding
Symptom Possible Cause Remedy
Chain saw fails to oper-
ate
Kickback brake is activated
No power
Mains socket faulty
Extension cord damaged
Fuse faulty
Pull hand guard 5 back in position ➊
(Figure D)
Check power
Use another socket
Check cord, replace
Replace fuse
Chain saw operates
intermittently
Extension cord damaged
Loose connection
Internal wiring defective
On/Off switch defective
Check cord, replace
Contact service agent
Contact service agent
Contact service agent
Dry chain No oil in reservoir
Vent in oil filler cap clogged
Oil passage clogged
Refill oil
Clean cap
Clean oil passage outlet
Kickback Brake/Run
Down Brake
Brake does not stop chain Contact service agent
Chain/chain bar over-
heats
No oil in reservoir
Vent in oil filler cap clogged
Oil passage clogged
Chain is over tensioned
Dull chain
Refill oil
Clean cap
Clean oil passage outlet
Adjust chain tension
Sharpen chain or replace
Chain saw rips, vibrates,
does not saw properly
Chain tension too loose
Dull chain
Chain worn out
Chain teeth are facing in the wrong
direction
Adjust chain tension
Sharpen chain or replace
Replace chain
Reassemble with chain in correct
direction
F016 L70 495.book Seite 9 Dienstag, 19. Dezember 2006 3:13 15
To Next Page
Loading...
