English - 3
1 • F016 L70 495 • TMS • 19.12.06
The chain saw is intended for sawing of trees, tree
trunks, branches, wooden beams, planks, etc. Cuts
can be sawed with or across the grain. This product
is not suitable for sawing mineral materials.
This manual gives instructions on the correct as-
sembly and safe use of your chain saw. It is impor-
tant that you read these instructions carefully.
Carefully remove the machine from its packaging
and check for complete contents:
– Chain saw
– Cover plate
– Chain
– Chain bar
– Chain guard
– Chain oil (80 ml)
– Operating instructions
When parts are missing or damaged, please contact your
dealer.
1 Rear handle
2 On/Off switch
3 Lock-off button
4 Oil filler cap
5 Activation lever for kickback brake (hand guard)
6 Front handle
7 Nose sprocket (AKE 35/40 only)
8 Chain guard
9 Chain
10 Chain bar
11 Gripping teeth
12 Locking knob
13 Cover plate
14 Chain tensioning knob
15 Fastening bolt
16 Chain tensioning peg
17 Guide fins for chain bar
18 Oil outlet
19 Symbol for rotation and cutting direction
20 Drive sprocket
21 Chain catch bolt
22 Mains plug**
23 Serial Number
**Country specific
Not all of the accessories illustrated or described are
included as standard delivery.
Product Specification
Chain saw AKE 30 S AKE 35 S AKE 40 S
Part number (typ) 3 600 H34 1.. 3 600 H34 1.. 3 600 H34 1..
Rated power [W] 1700 1700 1700
Chain speed (no load) [m/s] 9 9 9
Chain bar length [cm] 30 35 40
Tool-less chain tensioning (SDS) ● ● ●
Nose sprocket – ● ●
Kickback Brake ● ● ●
Chain type 3/8" - 90 3/8" - 90 3/8" - 90
Drive link thickness [mm] 1.1 (0.043") 1.1 (0.043") 1.1 (0.043")
Amount of drive links 45 52 57
Oil reservoir capacity [ml] 200 200 200
Automatic oiler ● ● ●
Metal gripping teeth ● ● ●
Weight without mains cable. approx. ** [kg] 3.9 4.0 4.1
Protection class / II / II / II
**measured with chain bar and chain
Note: Please observe the order number of your machine. The trade names of individual machines can vary.
Inrush currents cause short-time voltage drops. Under unfavourable power supply conditions, other equipment may be af-
fected. If the system impedance of the power supply is lower than 0,25 Ohm, disturbances are unlikely to occur.
Intended Use
Introduction
Delivered Items
Operating Controls
A
F016 L70 495.book Seite 3 Dienstag, 19. Dezember 2006 3:13 15
To Next Page
Loading...
