To Next PageTo Next Page
Need help?Do you have a question about the Bosch AQUATAK 1500 X and is the answer not in the manual?
General| Brand | Bosch |
|---|---|
| Model | AQUATAK 1500 X |
| Category | Pressure Washer |
| Language | English |
Read operating instructions and safety notes before machine use.
Ensure correct voltage, earthing, and use of extension cords for safe power connection.
Comply with regulations, ensure sealed joints, and check hose integrity.
Check unit condition, avoid solvents, observe safety in dangerous areas.
Operate according to regulations, avoid directing jet at people/animals, supervise unit.
Secure unit before transport, switch off motor.
Disconnect power/water, perform regular checks, use authorized service.
Use only manufacturer-approved accessories and spare parts for safe operation.
For cleaning outdoor areas, tools, vehicles, boats; not for professional use.
Intended for operation within 0 °C and 40 °C ambient temperature.
Provides instructions for correct assembly and safe use of the machine.
Machine weighs approximately 16-19 kg when fully assembled.
Lists power washer, power gun, hoses, lances, inlet connector, and operating instructions.
Lists and numbers key components like trigger, power gun, hoses, and tanks.
Ensure earth connection, use approved extension cables, check RCD.
Fit cable winder, handle, and inlet connector to the machine.
Securely screw high pressure hose to machine, hose drum, and power gun.
Insert and lock the vario-jet-fan power lance into the power gun.
Unwind pressure hose from drum; never use with hose on drum.
Adjust spray pattern by twisting the front ring and mode by the rear ring.
Extract vario-jet-fan lance and insert roto-power lance, lock in place.
Connect power, open water, prime with trigger, then start main switch.
Release trigger, lock safety, switch off main switch, close water, unplug.
Ensure level ground, avoid hose strain, do not drive over hose.
Use Bosch approved detergents, fill tank, dilute as recommended.
Remove, rinse, and replace the water inlet strainer; never operate without it.
Use top handle and wheels to move; lift by handle for steps/obstacles.
Drain detergent tank before storing or transporting horizontally.
Clean exterior, remove debris, store in frost-free room, avoid trapping cables.
Check plug, socket, fuse, extension cable, or motor protector activation.
Check fuse, mains voltage, motor protector, or if frozen.
Check fuse rating and mains supply voltage.
Check nozzle for blockage.
Check for air in the supply hose or partially blocked nozzle.
Check water supply, strainer, hoses, or nozzle wear.
Verify water supply, clean strainer/nozzle, or check pump/gun for leaks.
Contact service center if the pressure washer starts irregularly by itself.
Contact service center for significant leaks from the machine.
Prevent chemicals from entering the environment; observe agent instructions.
Recycle power tools and accessories; do not dispose of in household waste.
Find exploded views and spare parts online; contact service centers for support.
Product conforms to EU directives; lists noise and vibration levels.
