English | 17
Bosch Power Tools F 016 L81 061 | (27.2.15)
Declaration of Conformity
Equipment category: 33
Notified body:
SRL, Sudbury, England, Nr. 1088
Technical file (2006/42/EC, 2000/14/EC) at:
Bosch Lawn and Garden Ltd., PT-HG/ENS-PA2
Stowmarket, Suffolk IP14 1EY, England
Robert Bosch GmbH, Power Tools Division
70764 Leinfelden-Echterdingen, GERMANY
23.02.2015
Mounting and Operation
Starting
For Your Safety
Warning: Switch off and remove battery from machine
before adjusting or cleaning.
The blade continues to rotate for a few seconds after
the cordless trimmer is switched off. Allow the mo-
tor/blade to stop rotating before switching “on” again.
Do not rapidly switch off and on.
Only use Bosch approved cutting elements. Cutting
performance will vary with different cutting elements.
Battery Charging
Do not use other battery chargers. The supplied battery
charger is designed for the Lithium-Ion battery in your gar-
den product.
Observe the mains voltage! The voltage of the power
supply must correspond with the data given on the name-
plate of the battery charger. Battery chargers marked with
230 V can also be operated with 220 V.
The battery is equipped with temperature monitoring that al-
lows charging only in the temperature range between 0 °C
and 45 °C. In this manner, a high battery service life is
achieved.
Note: The battery supplied is partially charged. To ensure full
capacity of the battery, completely charge the battery in the
battery charger before using your power tool for the first time.
The lithium-ion battery can be charged at any time without re-
ducing its service life. Interrupting the charging procedure
does not damage the battery.
The “Electronic Cell Protection (ECP)” protects the lithium-
ion battery against deep discharging. When the battery is run
down or discharged, the garden product is shut off by means
of a protective circuit: The blade no longer moves.
Do not continue to press the On/Off
switch after the garden product has
been automatically switched off. The battery can be dam-
aged.
ART 23-18 LI ART 23-18 LI+ ART 26-18 LI ART 26-18 LI+
3 600 ... HA5 C.. HA5 C.. HA5 E.. HA5 E..
We declare under our sole responsibility that
the product described under “Technical da-
ta” is in conformity with all relevant provi-
sions of the directives 2011/65/EU, until 19
April 2016: 2004/108/EC, from 20 April
2016 on: 2014/30/EU, 2006/42/EC,
2000/14/EC including their amendments
and complies with the following standards:
EN 60335-1, EN 50636-2-91.
2000/14/EC: Guaranteed sound power lev-
el:
Conformity assessment procedure accord-
ing to Annex VI.
dB(A) 88 88 91 91
Henk Becker
Executive Vice President
Engineering
Helmut Heinzelmann
Head of Product Certification
PT/ETM9
Action Figure Page
Delivery Scope
1 256
Mounting the Cutting Guard
2 256
Adjusting the Handle
3 257
Mounting wheels
4 257
Charging the Battery Pack
Inserting and removing the battery
pack
5 257
Check the blade
6 258
Replace the blade
7 258
Setting Handle Angle
8 258
Switching On and Off
9 259
Working Advice
Adjusting the Cutting Height
10 259
Maintenance, Cleaning and Storage
11 259
Selecting Accessories
12 260
OBJ_BUCH-1981-003.book Page 17 Friday, February 27, 2015 8:13 AM
To Next Page
Loading...
