EasyManua.ls Logo

Bosch ASM 32 - For Your Safety; Blade Rotation Warning; Electrical Safety; Extension Cable Guidelines

Bosch ASM 32
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
18 | English
F 016 L70 798 | (15.4.11) Bosch Power Tools
Noise/Vibration Information
Measured sound values determined according
to EN 60335.
Typically the A-weighted noise levels of the
product are: Sound pressure level 79 dB(A);
sound power level 92 dB(A). Uncertainty
K=2dB.
Vibration total values a
h
(triax vector sum) and
uncertainty K determined according to
EN 60335:
a
h
<2.5 m/s
2
, K =1.5 m/s
2
.
Declaration of Conformity
We declare under our sole responsibility that
the product described under “Technical data” is
in conformity with the following standards or
standardization documents: EN 60335 accord-
ing to the provisions of the directives
2004/108/EC, 2006/42/EC, 2000/14/EC.
2000/14/EC: Guaranteed sound power level
96 dB(A). Conformity assessment procedure
according to Annex VI.
Equipment category: 32
Notified body:
SRL, Sudbury, England, Nr. 1088
Technical file at:
Bosch Lawn and Garden Ltd., PT-LG/EAE,
Stowmarket, Suffolk IP14 1EY, England
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
21.02.2011
Assembly
f Warning! Switch off, remove plug from
mains before adjusting, cleaning or if cable
is cut, damaged or entangled.
For Your Safety
f The blades continue to rotate for a few sec-
onds after the machine is switched off.
f Caution do not touch the rotating blades.
Electrical Safety
Your machine is double insulated for safety and
requires no earth connection. The operating
voltage is 230 V AC, 50 Hz (for non-EU countries
220 V, 240 V as applicable). Only use approved
extension cables. Contact your Bosch Service
Centre for details.
Extension cords/leads should only be used if
they comply with H05VV-F, H05RN-F types or
IEC type design (60227 IEC 53, 60245 IEC 57).
If you want to use an extension cable when op-
erating your product, only the following cable di-
mensions should be used:
–1.0mm
2
: max. length 40 m
1.5 mm
2
: max. length 60 m
2.5 mm
2
: max. length 100 m
Note: If an extension cable is used it must be
earthed and connected through the plug to the
earth cable of your supply network in accord-
ance with prescribed safety regulations.
If in doubt contact a qualified electrician or the
nearest Bosch Service Centre.
f WARNING! Inadequate extension cables
can be dangerous. Extension cable, plug
and socket must be of watertight construc-
tion and intended for outdoor use.
Cable connections should be kept dry and off
the ground.
It is recommended for increased electrical safe-
ty to use a Residual Current Device (RCD) with
a tripping current of not more than 30 mA. Al-
ways check your RCD every time you use it.
For products not sold in GB:
WARNING: For your safety, it is required that
the plug attached to the machine is connected
with the extension cord. The coupling of the ex-
tension cord must be protected against splash
water, be made of rubber or coated with rubber.
The extension cord must be used with a cable
strain relief.
Dr. Egbert Schneider
Senior Vice President
Engineering
Dr. Eckerhard Strötgen
Head of Product
Certification
OBJ_BUCH-1393-001.book Page 18 Friday, April 15, 2011 10:36 AM

Other manuals for Bosch ASM 32

Related product manuals