Bosch CityMower 18V-32-300

Questions and Answers

J
Jacob SmithJul 29, 2025
Why won't my Bosch CityMower 18V-32-300 motor start?
- N
  Nicole CollinsJul 29, 2025
  If your Bosch Lawn Mower's motor won't start, here are a few things to check: * **Battery:** Ensure the battery is charged. If it's too hot or cold, allow it to cool or warm to room temperature. * **Grass Length:** If the grass is too long, the motor may struggle. The maximum allowed grass height is 15 cm on the highest height-of-cut setting. * **Motor Protector:** The motor protector might have activated. Allow the motor to cool and increase the height of cut. * **Isolator Key:** Make sure the isolator key is correctly and fully inserted.
C
Christopher WilliamsAug 3, 2025
What to do if my Bosch CityMower 18V-32-300 functions intermittently?
- J
  Joshua SalinasAug 3, 2025
  If your Bosch Lawn Mower functions intermittently, it could be due to the motor protector activating. Allow the motor to cool, and increase the height of cut.
R
Ryan NguyenAug 10, 2025
What to do if my Bosch CityMower 18V-32-300 Lawn Mower leaves a ragged finish?
- B
  Brendan CrosbyAug 10, 2025
  If your Bosch Lawn Mower is leaving a ragged finish, it could be due to several reasons: * **Cutting Height:** The height of cut might be too low. Increase it to see if that improves the finish. * **Blade Condition:** The cutting blade may be blunt. If so, replace it. * **Clogging:** There might be clogging. Switch the lawn mower off and disengage the isolator key to clear any obstructions.
R
Richard CarterAug 15, 2025
Why is my Bosch CityMower 18V-32-300 motor labouring?
- A
  Amanda LaraAug 15, 2025
  If the motor of your Bosch Lawn Mower is laboring, consider the following: * Check underneath the lawn mower and clear out any obstructions. * Ensure the blade is fitted correctly and not upside down; refit if necessary. * Clear any obstructions that may be preventing the blade from rotating. * Make sure the blade nut/bolt is tightened to 17 Nm.
J
Jordan McphersonAug 21, 2025
How to fix excessive vibrations or noise in my Bosch CityMower 18V-32-300?
- P
  Peter HoodAug 21, 2025
  Excessive vibrations or noise in your Bosch Lawn Mower can be caused by: * **Loose Blade:** Tighten the blade nut/bolt to 17 Nm. * **Damaged Blade:** Replace the cutting blade if it's damaged.

Summary

Safety Notes

Explanation of Symbols

Operation

Operator Age and Supervision

Leaf Collect

Remove Isolator Switch

Battery Safety Instructions

Battery Insertion Safety

Ensure product is off and isolator key is off before inserting battery. Inserting battery into powered product can cause accidents.

Battery Compatibility

Use only Bosch batteries intended for this product. Other batteries may pose injury or fire risk.

Intended Use

Noise and Vibration Information

Mounting and Operation

Starting Operation

Safety Precautions for Starting

Switch off, remove isolator switch and battery before adjusting/cleaning. Blade rotates after switch off. Do not touch rotating blade.

Charging the Battery

Battery Temperature Monitoring

Battery charges only in 0-35 °C range for optimal service life. Battery is supplied partially charged.

Battery Protection

Electronic Cell Protection (ECP) protects against deep discharge. Product shuts off when battery is empty.

Inserting and Removing the Battery

Indicators (AL 1810)

Indicators (AL 1815 CV)

Indicators (AL 1830 CV;AL 1880 CV)

Working Advice

Cutting Capacity and Battery Duration

Troubleshooting

Maintenance, Cleaning and Storage

Battery Maintenance

Battery Protection and Storage

Bosch CityMower 18V-32-300 Specifications

General

Power Source	Battery
Battery Voltage	18V
Battery Type	Lithium-ion
Cutting Width	32 cm
Cutting Height Adjustment Type	Central
Grass Box Capacity	31 L
Weight (without battery)	8.4 kg
Cutting Height	30-60 mm