Bosch Indego 1100 Connect

Questions and Answers

E
Elizabeth PriceAug 4, 2025
What to do if Bosch Lawn and Garden Equipment machine fails to operate?
- D
  Donald HarmonAug 4, 2025
  If your Bosch Lawn and Garden Equipment fails to operate, consider these potential causes and solutions: First, check underneath the garden product for any clogging and clear it out, wearing protective gloves. If there's no clogging, ensure the battery is fully charged by replacing the garden product in the docking station. If the grass is too long, increase the height of cut. Also, check if the battery is too hot or cold, and allow it to cool or warm. Finally, make sure the isolator key is correctly and fully inserted.
T
Terri BraunAug 8, 2025
Why does my Bosch Lawn and Garden Equipment leave a ragged finish?
- S
  Stephanie HarperAug 8, 2025
  If your Bosch Lawn and Garden Equipment is leaving a ragged finish, it could be due to a few reasons. The height of cut might be too low, so try increasing it. Another possibility is that the cutting blade is blunt, in which case you should replace it. Also, check underneath the garden product for any clogging and clear it out as necessary, always wearing protective gloves.
K
Kelly SmithAug 13, 2025
Why is my Bosch Lawn and Garden Equipment leaving areas uncut?
- E
  ellen00Aug 13, 2025
  If your Bosch Lawn and Garden Equipment is leaving areas uncut, it could be due to several factors. First, the time slot might not be long enough for the garden size, so increase the mowing time slot. If the distance between obstacles surrounded by the perimeter wire is less than 1 m, increase the distance between the perimeter wire. For rough lawn conditions, increase or decrease cutting lane proximity from 'mow settings'.
A
Adam LeeAug 17, 2025
What to do if Bosch Lawn and Garden Equipment motor starts and stops immediately?
- R
  ralph36Aug 17, 2025
  If the motor of your Bosch Lawn and Garden Equipment starts and stops immediately, try these solutions: Ensure the battery is fully charged by placing the garden product in the docking station. Check that the isolator key is correctly and fully inserted. Also, the battery might be too hot or too cold; allow it to cool or warm. Finally, increase the height of cut.
C
Curtis HensonAug 21, 2025
Why is my Bosch Lawn and Garden Equipment making excessive vibrations or noise?
- M
  Melissa PearsonAug 21, 2025
  If your Bosch Lawn and Garden Equipment is experiencing excessive vibrations or noise, check if the blade nut or bolt is loose and tighten it. If that's not the issue, the cutting blade might be damaged and need replacement.
D
David ReyesAug 26, 2025
What to do if Bosch Lawn and Garden Equipment is unable to dock?
- S
  Stephanie JonesAug 27, 2025
  If your Bosch Lawn and Garden Equipment is unable to dock, check the perimeter wire and align it correctly. Also, ensure there is adequate distance (approximately 1 m) between your perimeter wire and any source of interference.
M
Michael WebbAug 30, 2025
Why is the LED on my Bosch Lawn and Garden Equipment docking station flashing?
- K
  keith47Aug 30, 2025
  If the LED on your Bosch Lawn and Garden Equipment docking station is flashing, the perimeter wire might be broken, too long, or too short. Check that the perimeter wire is not broken and is between 20 and 450 meters in length. Then, switch off and on the power supply.

Summary

Safety and Operation

Safety Notes

Read instructions carefully and be familiar with controls and proper use.

Symbols Explanation

Operational Precautions

Warnings and precautions for operating the robotic mower, including user responsibility.

Maintenance and Safety Procedures

Isolator Key Removal

Instructions for removing the isolator key before maintenance or work on the machine.

Product Handling and Storage

Battery Safety and Hazards

Docking Station Safety

Installation Guide

Lawn Preparation

Docking Station Setup

Guidance on positioning and securing the docking station for optimal performance.

Perimeter Wire Installation

Instructions for laying out and connecting the perimeter wire to define the mowing area.

Initial Setup and Configuration

PIN Code Setup

Setting a personal identification number for security and operation.

Mowing Schedules

Setting Up Mowing Schedules

Intelligent Cutting Features

Logicut Intelligent Cutting

How the Indego learns lawn shape for efficient cutting cycles.

Mapping the Cutting Area

Process of the Indego mapping the garden shape by following the perimeter wire.

Operation Features

Intelligent Cutting and Mapping

Learning garden objects, mapping, and efficient cutting modes.

Cutting Modes and Control

Machine Sensors

Details on lift, roll over, obstruction, and tilt sensors for safety.

Battery Charging and Management

Menu Navigation and Settings

Troubleshooting

Machine Fails to Operate

Identifies causes and solutions for the machine not starting or operating.

Motor Starts and Stops

Intermittent Machine Functions

Ragged Finish and Uncut Areas

Troubleshooting and Support

Charging and Docking Issues

Bosch Indego 1100 Connect Specifications

General

Max Area Capacity	1100 m²
Battery Voltage	18 V
Battery Type	Lithium-ion
Typical Mowing Time per Battery Charge	60 min
Typical Charging Time	60 min
Operating Time	up to 60 min
Cutting Height	30 – 50 mm
Cutting Height Settings	5 levels
Blade Type	3 blades