Bosch Indego 1000 Connect

Questions and Answers

J
Jamie BrownAug 4, 2025
What to do if Bosch Lawn and Garden Equipment machine fails to operate?
- M
  michellerubioAug 4, 2025
  If your Bosch Lawn and Garden Equipment fails to operate, consider these potential causes and solutions: First, check underneath the garden product for any clogging and clear it out, wearing protective gloves. If there's no clogging, ensure the battery is fully charged by replacing the garden product in the docking station. If the grass is too long, increase the height of cut. Also, check if the battery is too hot or cold, and allow it to cool or warm. Finally, make sure the isolator key is correctly and fully inserted.
O
ortegabethAug 8, 2025
Why does my Bosch Lawn and Garden Equipment leave a ragged finish?
- D
  David TuckerAug 8, 2025
  If your Bosch Lawn and Garden Equipment is leaving a ragged finish, it could be due to a few reasons. The height of cut might be too low, so try increasing it. Another possibility is that the cutting blade is blunt, in which case you should replace it. Also, check underneath the garden product for any clogging and clear it out as necessary, always wearing protective gloves.
J
Jeffery KlineAug 12, 2025
Why is my Bosch Lawn and Garden Equipment leaving areas uncut?
- J
  jonathan06Aug 13, 2025
  If your Bosch Lawn and Garden Equipment is leaving areas uncut, it could be due to several factors. First, the time slot might not be long enough for the garden size, so increase the mowing time slot. If the distance between obstacles surrounded by the perimeter wire is less than 1 m, increase the distance between the perimeter wire. For rough lawn conditions, increase or decrease cutting lane proximity from 'mow settings'.
S
Steven StephensAug 17, 2025
What to do if Bosch Lawn and Garden Equipment motor starts and stops immediately?
- D
  denisesmithAug 17, 2025
  If the motor of your Bosch Lawn and Garden Equipment starts and stops immediately, try these solutions: Ensure the battery is fully charged by placing the garden product in the docking station. Check that the isolator key is correctly and fully inserted. Also, the battery might be too hot or too cold; allow it to cool or warm. Finally, increase the height of cut.
J
jeffrey96Aug 21, 2025
Why is my Bosch Lawn and Garden Equipment making excessive vibrations or noise?
- S
  sarahmuellerAug 21, 2025
  If your Bosch Lawn and Garden Equipment is experiencing excessive vibrations or noise, check if the blade nut or bolt is loose and tighten it. If that's not the issue, the cutting blade might be damaged and need replacement.
D
Doris GarciaAug 26, 2025
What to do if Bosch Lawn and Garden Equipment is unable to dock?
- S
  Scott EatonAug 26, 2025
  If your Bosch Lawn and Garden Equipment is unable to dock, check the perimeter wire and align it correctly. Also, ensure there is adequate distance (approximately 1 m) between your perimeter wire and any source of interference.
J
John OsbornAug 29, 2025
Why is the LED on my Bosch Lawn and Garden Equipment docking station flashing?
- M
  Melissa LloydAug 29, 2025
  If the LED on your Bosch Lawn and Garden Equipment docking station is flashing, the perimeter wire might be broken, too long, or too short. Check that the perimeter wire is not broken and is between 20 and 450 meters in length. Then, switch off and on the power supply.

Summary

Safety Notes and Operation Guidelines

Explanation of Symbols

Explains symbols used on the mower for safety and operation.

General Operation Safety Precautions

Key safety instructions for operating the Indego mower.

Maintenance Procedures

Isolator Key Removal Instructions

Instructions on when and how to remove the isolator key for safety.

Cleaning and Component Upkeep

Procedures for cleaning the machine and checking components.

Docking Station and Power Supply Safety

Power Supply Safety Precautions

Safety warnings for using the docking station and power supply.

Docking Station Safety Regulations

General Safety Rules for Docking Station

Safety rules for operating the docking station and power supply.

Electrical Safety Guidelines for Power Supply

Guidelines on voltage, circuit breakers, and cord inspection.

Installation Guide Procedures

Lawn Preparation Steps

Docking Station Placement Guidelines

Guidelines for positioning the docking station.

Initial Setup and Configuration Process

Region and PIN Code Setup Procedure

Steps for setting the region and personal PIN code.

Installation Process Details

Garden Mapping Procedure Steps

Process of mapping the garden by following the perimeter wire.

Obstacle Handling During Mapping Process

Mowing Operations and Intelligent Cutting

Editing Mowing Schedule Slots

Mowing Modes Explanation

Logicut Intelligent Cutting Explained

How the Indego learns lawn shape for efficient cutting.

Garden Mapping and Cutting Feature Details

Learning Garden Object Locations

How the Indego maps objects within the garden.

Menu Navigation and Troubleshooting Start

Daily Timer and Schedule Settings

Troubleshooting: Machine Operation Issues

Common causes and solutions for the mower not starting or stopping.

Troubleshooting and After-Sales Service

Troubleshooting: Intermittent Function and Finish Quality

Troubleshooting: Vibrations and Noise Issues

Bosch Indego 1000 Connect Specifications

General

Type	Robotic lawn mower
Cutting width	260 mm
Grass catcher	Yes
Cutting height	20 - 60 mm
Cutting system	Rotary blades
Number of blades	3
Recommended lawn area	1000 m²
Maximum cutting height	60 mm
Minimum cutting height	20 mm
Grass collecting volume	- L
Maximum speed (forward)	1.62 km/h
Cutting clearance adjustment	10
Power source	Battery
Charging time	0.83 h
Battery voltage	32.4 V