Bosch Indego 1200 Connect

Questions and Answers

C
Charles SmithAug 4, 2025
What to do if Bosch Lawn and Garden Equipment machine fails to operate?
- T
  torresgaryAug 4, 2025
  If your Bosch Lawn and Garden Equipment fails to operate, consider these potential causes and solutions: First, check underneath the garden product for any clogging and clear it out, wearing protective gloves. If there's no clogging, ensure the battery is fully charged by replacing the garden product in the docking station. If the grass is too long, increase the height of cut. Also, check if the battery is too hot or cold, and allow it to cool or warm. Finally, make sure the isolator key is correctly and fully inserted.
M
Michael AtkinsAug 8, 2025
Why does my Bosch Lawn and Garden Equipment leave a ragged finish?
- S
  Scott WeeksAug 8, 2025
  If your Bosch Lawn and Garden Equipment is leaving a ragged finish, it could be due to a few reasons. The height of cut might be too low, so try increasing it. Another possibility is that the cutting blade is blunt, in which case you should replace it. Also, check underneath the garden product for any clogging and clear it out as necessary, always wearing protective gloves.
K
Krista BrownAug 12, 2025
Why is my Bosch Lawn and Garden Equipment leaving areas uncut?
- D
  donna50Aug 12, 2025
  If your Bosch Lawn and Garden Equipment is leaving areas uncut, it could be due to several factors. First, the time slot might not be long enough for the garden size, so increase the mowing time slot. If the distance between obstacles surrounded by the perimeter wire is less than 1 m, increase the distance between the perimeter wire. For rough lawn conditions, increase or decrease cutting lane proximity from 'mow settings'.
C
Christina LewisAug 17, 2025
What to do if Bosch Lawn and Garden Equipment motor starts and stops immediately?
- J
  Joshua MillerAug 17, 2025
  If the motor of your Bosch Lawn and Garden Equipment starts and stops immediately, try these solutions: Ensure the battery is fully charged by placing the garden product in the docking station. Check that the isolator key is correctly and fully inserted. Also, the battery might be too hot or too cold; allow it to cool or warm. Finally, increase the height of cut.
D
Diane JacksonAug 21, 2025
Why is my Bosch Lawn and Garden Equipment making excessive vibrations or noise?
- A
  Andrea BarnesAug 21, 2025
  If your Bosch Lawn and Garden Equipment is experiencing excessive vibrations or noise, check if the blade nut or bolt is loose and tighten it. If that's not the issue, the cutting blade might be damaged and need replacement.
D
Donna RobinsonAug 26, 2025
What to do if Bosch Lawn and Garden Equipment is unable to dock?
- P
  Patrick ReynoldsAug 26, 2025
  If your Bosch Lawn and Garden Equipment is unable to dock, check the perimeter wire and align it correctly. Also, ensure there is adequate distance (approximately 1 m) between your perimeter wire and any source of interference.
S
smalljacobAug 30, 2025
Why is the LED on my Bosch Lawn and Garden Equipment docking station flashing?
- C
  Christine Martinez DDSAug 30, 2025
  If the LED on your Bosch Lawn and Garden Equipment docking station is flashing, the perimeter wire might be broken, too long, or too short. Check that the perimeter wire is not broken and is between 20 and 450 meters in length. Then, switch off and on the power supply.

Summary

Safety Notes and Operation Guidelines

Explanation of Symbols

Safe Usage and Emergency Stop

Details safe operation, supervision, operator responsibility, and emergency stop procedures.

Maintenance and Safety Procedures

Maintenance Safety Precautions

Cleaning and Blade Care

Winter Storage, Battery, and Docking Station Safety

Battery Hazards and Handling

Covers safe recharging, operating temperature limits, and battery liquid precautions.

Safety Precautions for Docking Station and Power Supply

Safe Operation, Supervision, and Electrical Safety

Covers safe placement, child supervision, voltage matching, circuit protection, cord care, and cable management.

Initial Setup and Configuration

Connecting and Welcome Screen

Details plugging in the isolator key, charging, and understanding the welcome screen symbols.

Language and PIN Code Setup

Guides users through selecting the language and setting a personal PIN code for the mower.

Garden Mapping and Installation Progress

Perimeter Wire Mapping

Explains the process of mapping the garden by following the perimeter wire for initial setup.

Installation Progress and Troubleshooting

Mowing Schedule Setup and Garden Naming

Scheduling Options and Customization

Mowing Operations and Intelligent Cutting

Mowing Modes and Safety Precautions

Logicut Cutting Technology Explanation

Explains how the Indego learns lawn shape, maps objects, and plans efficient cutting paths.

Garden Mapping and Mowing Modes

Object Location Learning and Cutting Patterns

Explains how the Indego learns garden objects, uses cutting modes, and manages lawn areas.

Docking Station, Sensors, and Battery Charging

Schedule Controls and Troubleshooting

Problem Diagnosis and Corrective Actions

Lists common problems like machine failure, motor issues, ragged finish, and uncut areas with solutions.

Bosch Indego 1200 Connect Specifications

General

Battery Voltage	18 V
Battery Type	Lithium-ion
Cutting Height Adjustment	Central
Max Area Coverage	1200 m²
Weight	11.1 kg
Max. Gradient	35%
Mulching Capability	Yes
Cutting Height	2-5 cm
Noise Level	63 dB
Charging Time	50 minutes