Bosch B Series - User Manual

To Next Page

Bosch B/G Series Alarm System Instructions

Arming and Disarming Your System

To arm (turn on) your system:

The keypad must say “READY TO ARM.” If this message appears on the keypad, enter

your four-digit code on the keypad and then push the “ENT” (enter) key.

Your arming/disarming codes are: __________ ___________ ___________

___________ ___________ ___________ ___________ ___________

The keypad will then show “ALL SECURE, EXIT NOW.” You will hear the keypad

beep. You have __________ seconds to exit. Open the delay door and exit.

Your delay door is located at: ____________________.

Please note: All doors must be closed when arming the system.

To disarm (turn off) your system:

When entering the building, enter through the delay door ONLY.

Upon opening the door you will hear a beeping sound, this is the pre-alarm. You have

_________ seconds in which to enter the four-digit code to turn the system off. Enter

your four-digit code and press the ENT (enter) button.

If alarm occurs:

Put in your Code + Enter. This will silence the alarm. Check the zones that went into

alarm, which is displayed by the keypad. Once you have checked them, go back to the

keypad and push Enter + Your Code + Enter. This will clear the system out so you may

continue to arm and disarm.

Other manuals for Bosch B Series

Need help?

Do you have a question about the Bosch B Series and is the answer not in the manual?

General