69
10-4. Connect the Tubing to the Refrigerator
3) Place the compression nut and ferrule (sleeve) onto the end of the tubing as shown.
4) Insert the end of the tubing into the water valve connection as far as possible.
While holding the tubing, tighten the fitting.
5) and, tighten the compression nut until it is hand tight.
then tighten one additional turn with a wrench.
Overtightening may cause leaks.
Compression
Nut (1/4”)
Ferrule
(sleeve)
Refrigerator
connection
< Water Main Valve>
6) Plug the power cord and press the water dispenser button for 2~3minutes to flush out the tubing.
7) Check the water leak again through the water supply system (tubes, connectors and pipes).
Tubing (1/4”)
※ Before you begin, make sure the refrigerator power cord is not plugged into the wall outlet.
and, shut off the main water supply.
※ Water pressure should be 3kgf/cm2 or more to run the automatic icemaker.
1) The compressor compartment access cover must be removed
and remove the plastic cap of the water main(1-way) valve.
To Next Page
Loading...
