en-us
12
Sabbath mode
When Sabbath mode is switched on, the following
settings are switched off:
■ Super cooling (if switched on)
■ Super freezing (if switched on)
■ Ice maker
■ Acoustic signal
■ Interior light
■ Messages in the display panel
■ The background illumination of the display panel is
reduced
■ Buttons are locked
Switching on
1.
Press and hold down the “super” button
on refrigerator compartment.
2.
Press Vacation button.
3.
Press “super” button and hold down for a further
3seconds.
The VACATION symbol flashes on the display panel
and SABBATH is displayed.
Switching off
Press Vacation button.
The previous settings and temperature values are once
again activated.
Energy saving mode
If the energy saving function (eco function) is activated,
the appliance switches to energy saving operation. This
energy saving function is preset at the factory in order
to reduce energy consumption. The background
illumination of the fascia is likewise reduced.
Switching on
1.
Press setup button.
2.
Press the selection button ¿, until ECO MODE
and the current setting (OFF) is displayed.
3.
Press the setting button @, in order to reset
the setting.
4.
Press the setup button, in order to store the setting.
ECOis displayed in the fascia.
Switching off
1.
Press setup button.
2.
Press the selection button ¿, until ECO MODE
and the current setting (ON) is displayed.
3.
Press the setting button A, in order to reset
the setting.
4.
Press the setup button, in order to store the setting.
Door rail heater
To prevent condensation, the door rail heater can be
switched on and off as required.
Switching on
1.
Press setup button.
2.
Press the selection button ¿, until DRY DOOR
and the current setting (OFF) is displayed.
3.
Press the setting button @, in order to reset
the setting.
4.
Press the setup button, in order to store the setting.
Switching off
1.
Press setup button.
2.
Press the selection button ¿, until DRY DOOR
and the current setting (ON) is displayed.
3.
Press the setting button A, in order to reset
the setting.
4.
Press the setup button, in order to store the setting.
Alarm function
Switching off the warning signal
Press the “alarm” button to switch off the warning
signal.
Door alarm
The door alarm switches on if an appliance door is left
open for longer than three minutes. Close the door
to switch off the warning signal.
To Next Page
Loading...
