Installation and connection en-us
11
You can adjust the angle of the drawer:
1. Open the drawer as far as it will go and remove
the bottle shelves.
2. Remove the cover cap on both sides.
3. Loosen the upper and lower screw on both sides.
Note: Do not remove the screws.
4. Move the drawer on the lower screw to the left or
right into the required position and tighten the
screw.
5. Tighten all screws again and put the cover cap
back on.
6. To check the position, close the drawer and
correct if necessary.
To Next Page
Loading...
Need help?
General
