0 275 007 XCX | (24.04.2018) Bosch eBike Systems
Operation
Start-up
Connecting the charger to the mains (see figure A)
Pay attention to the mains voltage. The voltage of
the power source must match the voltage specified on
the rating plate of the charger. Chargers marked 230 V
can also be operated at 220 V.
Plug the device connector (3) of the power cable into
the device socket (2) on the charger.
Connect the power cable (country-specific) to the mains.
Charging the removed battery (see figure B)
Switch the battery off and remove it from its holder on
the eBike. When doing so, read and observe the
operating instructions of the battery. Ensure the
battery is placed on clean surfaces only. Avoid getting
dirt, e.g. sand or soil, in the charging socket and contacts
in particular.
Plug the charging connector (5) of the charger into the
socket (6) on the battery.
Charging the battery on the bike (see figures C and D)
Switch the battery off. Clean the cover of the charging
socket (7). Avoid getting dirt, e.g. sand or soil, in the
charging socket and contacts in particular. Lift the cover
of the charging socket (7) and plug the charging
connector (5) into the charging socket (6).
Charge the battery only in accordance with all
safety instructions. If this is not possible, remove the
battery from the holder and charge it in a more
suitable location.
When doing so, read and observe the operating
instructions of the battery.
Charging process for two batteries
If two batteries are fitted to an eBike, both batteries can
be charged using the uncovered connection. To begin
with, both batteries are charged one after the other
until they reach approx. 80–90 % capacity, then they are
both charged at the same time until full (the LED flashes
on both batteries).
When the bike is in operation, power is drawn from both
batteries on an alternating basis.
If you take the batteries out of the holders, you can
charge each one individually.
Charging process
To Next Page
Loading...
