Bosch BDU336Y - Page 176

English – 11
press the Bluetooth® button(1). The on-board com-
puter is then placed into stand-by mode.
Note: If you are not going to be using your eBike for
several weeks, remove the on-board computer from
its holder and set the on-board computer to storage
mode. To do so, press the Bluetooth® button(1) for 8
to 11s.
Once you reinsert the on-board computer back into
the holder and move the eBike, the storage mode will
be automatically deactivated.
The reset button(5) serves to reset the on-board
computer to factory settings and delete all connec-
tions.
The on-board computer can be operated via one of
the operating units shown. The functions of the but-
tons on the operating units are explained in the fol-
lowing overview.
Depending on how long it is pressed for, the select
button has 2functions.
Three-button operating unit
Five-button operating unit
Navigate left (five-button operating unit)
Navigate right (five-button operating unit)
Increase assistance level
Decrease assistance level
Select button (press briefly)
Select button (press and hold>1s)
Note: All interface displays and texts on the following
pages correspond to the release status of the soft-
ware. The interface displays and texts may change
slightly following a software update.
Note: Depending on the lighting conditions, there is
background lighting that is only activated by pressing
a button. The lighting duration can be adjusted.
Bosch eBike Systems 0 275 U07 3BI | (03.03.2023)