12
Changing the dust bag en
Replacing the dust bag
If the dust bag change indicator in the cover is
completely yellow when the floor tool is lifted off
the floor and the highest suction setting is
selected, the dust bag must be replaced even if it
should not be completely full yet. In this case it is
essential to change the dust bag due to the type of
material it contains. The nozzles, suction pipe and
flexible hose should not be blocked, as this will
also trigger the dust bag change indicator.
Open the cover by moving the locking lever in the
direction of the arrow.
When the work is done en
To release the connection, press the unlatching
sleeve and pull the telescopic tube out.
*
Depending on equipment level
*
Please refer to the enclosed operating instructions for information regarding
maintenance of the
ELECTROMATIC
®
brush and
TURBO-UNIVERSAL
®
brush.
(Depending on equipment level ).
To Next Page
Loading...
