EasyManua.ls Logo

Bosch CBG635B 3 Series - Rails and Appliance Door

Bosch CBG635B 3 Series
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
en Rails
18
6.
Use the control ring to set the temperature to
80°C.
7.
Press ⁠.
8.
Use the control ring to set the cooking time to
fourminutes.
9.
Press ⁠ to start.
a The appliance starts to heat and the cooking time
counts down.
a When the time has elapsed, a signal sounds. The
time shown in the display is zero.
10.
Use ⁠ to switch the appliance off and leave the
cooking compartment to cool for approx.
20minutes.
16.2 Wiping down the cooking compartment
ATTENTION!
The prolonged presence of moisture in the cooking
compartment leads to corrosion.
After using the cleaning assistance, wipe the cook-
ing compartment and allow it to dry completely.
Requirement:The cooking compartment must have
cooled down.
1.
Open the appliance door and remove the remaining
water with an absorbent sponge cloth.
2.
Clean the smooth surfaces in the cooking compart-
ment with a dish cloth or a soft brush. Remove stub-
born food remnants using a stainless steel scouring
pad.
3.
Remove limescale with a cloth soaked in vinegar.
Then wipe with clean water and rub dry with a soft
cloth (including under the door seal).
4.
In order to dry the cooking compartment, leave the
appliance door open in the detent position (approx.
30°) for approx.one hour.
17  Rails
To thoroughly clean the rails and the cooking compart-
ment, or to replace the rails, you can remove the rails.
17.1 Detaching the rails
WARNING‒Risk of burns!
The shelf supports get very hot
Never touch the shelf supports when hot.
Always allow the appliance to cool down.
Keep children at a safe distance.
1.
Lift the rail forwards slightly ⁠ and detach it ⁠.
2.
Pull the whole rail to the front ⁠ and remove it.
3.
Clean the rail.
→"Cleaning products", Page15
17.2 Attaching the rails
Notes
¡ The rails only fit on the right or left.
¡ For both rails, ensure that the curved rods are at the
front.
1.
First, push the rail into the middle of the rear
socket ⁠ until the rail rests against the cooking
compartment wall, and then push this back ⁠.
2.
Push the rail into the front socket ⁠ until the rail
also rests against the cooking compartment wall,
and then press this downwards ⁠.

Related product manuals