Need help?Do you have a question about the Bosch CC880/LP880, SC8016 and is the answer not in the manual?
General| Brand | Bosch |
|---|---|
| Model | CC880/LP880, SC8016 |
| Category | Security System |
| Language | English |
Details the status of zones 1 to 8, including sealed, unsealed, and alarm conditions.
Indicates when the system is armed in AWAY Mode.
Shows when the system is armed in STAY Mode 1 or STAY Mode 2.
Indicates when the system is in the disarmed state.
Displays the status of the AC mains power supply.
Shows the system disarmed state and flashes when a zone is unsealed.
Indicates when the system is armed in AWAY Mode and flashes on alarm.
Signals when the system detects a fault.
Describes the audible signals emitted by the codepad buzzer.
Details how to arm the system when a zone is not sealed.
Explains how to arm the system when leaving the premises.
Describes arming the system to protect the perimeter while allowing movement.
Covers arming with automatic zone isolation for specific areas.
Instructions for programming zones to be automatically isolated in STAY Mode 2.
Allows operators to isolate zones without a user code.
Explains isolating zones using a user code with priority level.
Provides descriptions for various system faults like Battery Fail and Telephone Line Fail.
Tests the functionality of the horn speaker.
Verifies the operation of the bell output.
Checks the functionality of the strobe light.
Enables testing of detection devices to ensure correct operation.
Describes the indicators on a master partitioned codepad.
Explains how codepads function within a partitioned system.
Allows arming or disarming of all assigned areas simultaneously.
Details how the system acknowledges incoming domestic alarm calls.
Instructions for programming telephone numbers for domestic dialling.
Procedure to cancel the domestic dialling feature.
Explains how to acknowledge voice messages from alarm events.
Provides information on interpreting basic pager display codes.
Details settings for entry and exit timers for system arming.
Configurable options for system arming, including single button and remote arming.
Describes the function and configuration of system output devices.
Specifies the method used for isolating system zones.
Configuration settings for system communication methods.
Covers system parameters like siren run time and service technician details.
To Next Page