Bosch CMG676BB1 - Page 25

Drying en
25
19 Drying
To prevent residual moisture, dry the cooking compart-
ment following operation.
ATTENTION!
If there is water on the cooking compartment floor
when operating the appliance at temperatures above
120°C, this will damage the enamel.
▶ Do not use the appliance if there is water on the
cooking compartment floor.
▶ Wipe away any water on the cooking compartment
floor before operation.
19.1 Drying the cooking compartment
You can dry the cooking compartment by hand or use
the "Drying" function.
1.
Allow the appliance to cool down.
2.
Remove dirt from the cooking compartment.
3.
Wipe away the water in the cooking compartment.
4.
Dry the cooking compartment.
‒ Leave the cooking compartment to dry with the
appliance door open for 1hour.
‒ To use the "Drying" function, set "Drying".
→"Setting the drying process", Page25
Setting the drying process
Requirement:→"Drying the cooking compartment",
Page25
1.
Press ⁠.
2.
Press "Cleaning".
3.
Press "Drying".
a The duration appears in the display. The duration
cannot be changed.
4.
Press ⁠ to start.
a The drying process starts and the duration counts
down.
a Once the drying process has ended, an audible sig-
nal sounds and the display shows the cooking time
as zero.
5.
Press ⁠ to switch the appliance off.
6.
To dry the cooking compartment completely, leave
the appliance door open for 1 to 2 minutes.
20 Rails
To thoroughly clean the rails and the cooking compart-
ment, or to replace the rails, you can remove the rails.
20.1 Detaching the rails
WARNING‒Risk of burns!
The shelf supports get very hot
▶ Never touch the shelf supports when hot.
▶ Always allow the appliance to cool down.
▶ Keep children at a safe distance.
1.
Lift the rail forwards slightly ⁠ and detach it ⁠.
2.
Swivel the entire rail outwards ⁠ and unhook it at
the rear ⁠.
20.2 Fitting the retainers
The retainers may fall out when you detach the rails.
Note:
The retainers at the front differ from those at the rear.
1.
Hook the front retainers with the hook into the round
hole at the top and set them at a slight angle ⁠.
2.
Hook the front retainers in at the bottom and
straighten them ⁠.