Bosch DF481700F - Page 39

Troubleshooting en-us
39
Issue Cause and troubleshooting
E:6103 lights up. Water is not
draining.
▶ Secure the cover of the drain pump so it clicks into place or clean the drain
pump.
Not an appliance error. High loop is missing and/or debris flushed back into drain
hose and blocked it.
▶ Be sure there is a high loop in the drain hose and that no debris has flushed back
into the hose.
E:9001 lights up. Power voltage is too low.
There is no problem with the appliance.
1. Call an electrician.
2. Have the power voltage and electrical installation checked by an electrician.
E:9240 lights up. Filters are soiled or blocked.
▶ Clean the filters.
→
"Cleaning filters", Page35
A different error code appears in
the display window.
E:0100 to E:9010
There is a technical issue.
1. Press .
2. Pull out the power cord plug of the appliance or switch off the breaker.
3. Wait at least 2minutes.
4. Insert the power cord plug of the appliance in a power outlet or switch on the
breaker.
5. Switch the appliance on.
6. If the problem occurs again:
‒ Press ⁠.
‒ Turn off the water faucet.
‒ Pull out the power cord plug.
‒ Contact customer service →
Page47 and give the error code.
Dishware is not dry. No rinse aid used or dosage set too low.
1.
Add Rinse aid → Page24 .
2. Set the amount of rinse aid to be dispensed.
→
"Setting the amount of rinse aid", Page25
Cycle or cycle option has no drying phase, or drying phase is too short.
▶
Select a wash cycle with drying. → Page12
Some option buttons decrease the drying result.
Water collects in recesses of dishware or silverware.