English–6
Bosch eBike Systems 0 276 001 SPN | (3.7.15)
Operating mode “Dashboard”
This operating mode offers you statistical data.
d1 Clock
d2 Observation period
d3 Costs
d4 Savings
d5 Saved trees
d6 Total distance of cyclist
This operating mode shows you the savings d4 you have
made, when not using a car, but rather the eBike.
Basis for the calculation is the average energy cost of fuel and
electricity.
Operating mode “Ride”
This operating mode provides current journey data.
r1 Clock
r2 Own pedal power
r3 Speed
r4 Engine power
r5 Assistance-level indicator
r6 Trip meter
r7 Average speed
r8 Coverage
r9 Charge level indicator of the eBike battery pack
Operating mode “Map&Navigation”
You can use this operating mode to access map data based on
Open Street Map (OSM). You can navigate using these maps.
The map material suitable for the place of residence is in-
stalled by the bike dealer for the respective buyer. If required,
additional maps can be downloaded via your smartphone ap-
plication “Bosch eBike Connect” and be transferred to your
on-board computer. Detailed instructions can be found in the
online manual under
“www.Bosch-eBike.com/nyon-manual”.
If you have an active wi-fi connection and Nyon is connected
to a power supply via the USB port, maps can be loaded di-
rectly onto Nyon via “Settings” > “Map & Navigation” >
“Map Manager”.
When you switch on Nyon, it begins the satellite search to re-
ceive GPS signals. Once sufficient satellite signal is found, the
operating mode displays “Map&Navigation” of the current
location. In case of unfavourable weather conditions or loca-
tions, the satellite search may take a little longer.
Pressing the joystick 1 to the right allows you to change the
zoom configuration of the map section by selecting the sub
menu on the right side. You can display the range of your
eBike battery pack or choose one from different navigation
options. The zoom configurations for the map section can also
be changed by pressing the joystick.
Your nearest “Bosch eBike experts” are also shown under
“Points of Interest”. When you select a dealer, the route to it
will be calculated and made available for you to select.
If you have entered the destination (town, street, house num-
ber), three different routes (“Scenic”, “Fast” and “MTB”
(Mountain bike)) will be provided for you to choose from.
Alternatively, you can opt to be guided home, select one of
the last destinations used, or choose from saved locations
and routes. (Detailed instructions can be found in the online
manual under “www.Bosch-eBike.com/nyon-manual”.)
The selected route will be displayed as shown in the figure
below.
n1 Clock
n2
Map
n3 Zoom level
n4 Compass needle
n5 Turn instructions and distance to the next turn
n6 Distance to destination
n7 Estimated time of arrival at destination
To Next Page
Loading...
Need help?
General
