63
FOR THE INSTALLER
External connections to the heat pump
These are the external connections that must be made for the heat pump:
Power supply 3-phase: The power supply is connected to terminals L1, L2, L3, N and PE. In
the event of a possible phase sequence fault the heat pump will trip the alarm 3-phase incorrect.
See more information in the section What to do if a fault occurs.
Power supply 1-phase: The power supply is connected to terminals L, N, and PE.
Mixing valve on the heating circuit: If a second heat curve with a mixing valve is to be used,
the mixing valve is connected to terminal block SV1.
External main pump in the heating system G1 (P1): The external main pump must be
connected to the terminal card in those cases a bypass is required. The pump is connected to
terminal P1.
Return sensor radiator T1 (GT1): Must always be connected. Connect to terminal GT1.
Outdoor sensor T2 (GT2): Must always be connected. Connect to terminal GT2.
Hot water sensor T3 (GT3): Is connected if the heat pump is to produce hot water. Connect
to terminal block GT3 X on the terminal card. On the LW model this sensor is already
connected on delivery.
Mixing valve sensor T4 (GT4): Is connected when a mixing valve for a second heat curve is
to be used. Connect to terminal GT4.
Room sensor T5 (GT5): Is connected if room sensor infl uence is required.
Mixing
valve
G1 (P1)
Terminal card
230 V
Return radiator
Outdoor sensor
Hot water
Mixing valve
Room sensor
Alarm lamp, room sensor
Terminal card
for external
connections
Connecting the heat pump to the power supply
To Next Page
Loading...