13
To reduce the risk of injury read the operating instructions included
with Bosch GCY42 connectivity module. Operating instructions for GCY42
c
onnectivity module include important information not covered in this manual.
Connectivity
Bluetooth®
Do not use the power
tool with Bluetooth® in
the vicinity of gas stations, chemical
plants, areas where there is danger of
explosion and areas subject to blasting.
Do not use the power tool with
Bluetooth® in airplanes. Do not use the
power tool with Bluetooth® in the
vicinity of medical devices. Avoid
operation in the direct vicinity of the
human body over longer periods of
time. When using the power tool with
Bluetooth®, interference with other
devices and systems, airplanes and
medical devices (e.g., cardiac
pacemakers, hearing aids) may occur.
The Bluetooth® word mark and logos are
registered trademarks owned by
Bluetooth SIG, Inc. and any use of such
marks by Robert Bosch Tool Corporation
is under license.
Follow all instructions
and warnings provided
by your Bluetooth® device
manufacturer. Failure to follow
recommended procedures could result
in personal injury or property damage.
Exercise extreme
caution when using
Bluetooth® devices to control or change
power tool functions. Operation of the
device may be in a different area than
the paired power tool. Paired devices
may have functionality which allows
timed event programming, including
automatically powering on (e.g. flood
light). Depending upon the power tool,
these unattended operations or function
changes without direct line of sight to
the paired tool could result in personal
injury or property damage.
Always check tool
settings before use.
Settings may be different than when the
tool was last used. The connectivity
module enables transfer of data and
settings based on Bluetooth® wireless
technology. With module installed, select
tool settings may be changed remotely
by a paired Bluetooth® device and user
installed app.
The connectivity
module GCY42 is
equipped with a radio interface. Local
operating restrictions, e.g. in military
sites or hospitals, are to be observed.
Transmitters have demonstrated an
ability to unintentionally interfere with
other devices.
Think safety
SAFETY IS A COMBINATION OF
OPERATOR COMMON SENSE AND
ALERTNESS AT ALL TIMES WHEN THE
TOOL IS BEING USED.
FCC caution
The manufacturer is not responsible for
radio interference caused by
unauthorized modifications to this
equipment. Such modifications could
void the user’s authority to operate the
equipment.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
1) This device may not cause harmful interference,
and
2) This device must accept any interference
received, including interference that may cause
undesired operation.
NOTE! This equipment has been tested
and found to comply with the limits for a
Class B digital devices, pursuant to Part
15 of the FCC rules. These limits are
designed to provide reasonable
protection against harmful interference
in a residential installation. This
equipment generates, uses and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
To Next Page
Loading...
