10
Impact Wrench GDS18V-330C GDS18V-330PC
Rated voltage 18V 18V
No-load speed
A
– Setting 1 0–1000 RPM 0–1000 RPM
– Setting 2 0–1500 RPM 0–1500 RPM
– Setting 3 0–2300 RPM 0–2300 RPM
Impact rate
– Setting 1 0–1900 IPM 0–1900 IPM
– Setting 2 0–2500 IPM 0–2500 IPM
– Setting 3 0–3300 IPM 0–3300 IPM
Maximum torque
– Setting 1 185 Ft-lbs 185 Ft-lbs
– Setting 2 245 Ft-lbs 245 Ft-lbs
– Setting 3 330 Ft-lbs 330 Ft-lbs
Breakaway torque 590 Ft-lbs 590 Ft-lbs
Output drive
1/2” Square drive with
Friction Ring and Through-Hole
1/2" Square drive with
Detent Pin
Weight tool only 3.52 lbs 3.52 lbs
Permitted battery temperature
during charging
+32…+113°F (0…+45C) +32…+113°F (0…+45C)
Permitted ambient temperature
during operation and storage
-4…+122°F (-20…+50C) -4…+122°F (-20…+50C)
Recommended ambient
temperature during charging
+32…+95°F (0...+35°C) +32…+95°F (0...+35°C)
Data Transmission (GCY42 installed)
Bluetooth® Bluetooth® 4.1 (Low Energy)
B
Bluetooth® 4.1 (Low Energy)
B
Signal interval, approx. 8s 8s
Signal range maximum 98ft
C
maximum 98ft
C
Functional Description and Specifications
A
No-load speed settings represent factory presets.
B
The mobile terminal devices must be compatible with Bluetooth® Low Energy devices (version
4.1) and support the Generic Access Profile (GAP).
C
The signal range may vary greatly depending on external conditions. The Bluetooth® range may
be significantly weaker inside closed rooms and through metallic barriers (e.g. walls, shelving
units, cases, etc.).
Battery Packs / Chargers:
Please refer to the battery/charger list, included with your tool.
NOTE: For tool specifications refer to the nameplate on your tool.
To Next Page
Loading...
