11
Inserting and Releasing
Battery Pack
Set Forward/Reversing lever (3) to the
center (locked position). Slide charged
battery pack (5) into the housing until the
battery pack locks into position (Fig. 3).
Your tool is equipped with a secondary
locking latch to prevent the battery pack
from completely falling out of the handle,
should it become loose due to vibration.
To remove the battery pack, press the
battery pack release button (6) and slide
the battery pack (5) completely out of tool
housing (Fig. 4).
Inserting and Removing
Accessories
Attach only high quality impact ready
accessories with the proper size square
drive designed for use with impact
wrenches.
Model GDS18V-330C Only - is equipped
with a 1/2" square drive (1) with friction
ring and through-hole (2) (Fig. 5).
To Install a socket (10), simply push socket
completely onto output drive (1).
To remove, simply pull socket off the
output drive.
Through-hole allows for more secure socket
retention via compatible socket and use of
accessory pin and ring or one piece
retainer. Follow accessory retention device
manufacturer's recommendations for use of
through-hole.
Assembly
Fig. 5
GDS18V-330C
Disconnect battery pack from tool before making any assembly, adjustments
or changing accessories. Such preventive safety measures reduce the risk of
starting the tool accidentally.
To Next Page
Loading...
