9
Product Specification
Straight grinder GGS 27 L
Part number 0 601 215 ...
Rated power [W] 500
Output power [W] 300
Frequency [Hz] 50 / 60
Amperagem 115 V~ [A] 4,9
220 V~ [A] 2,5
No-load speed [min
-1
] 27.000
Collet chucks Ø máx. [mm] 8
Spindle neck Ø [mm] 35
Grinding tool Ø máx. [mm] 25
Weight approx. [Kg] 1,45
Safety class / II
Machine elements
1. Wrench*
2. Collet chuck*
3. Clamping nut*
4. Grinder spindle
5. Spindle collar
6. Ventilation slots
7. On/Off switch
8. Cable
9. Dressing stone*
10. Open-ended spanner*
*Accessory
*Not all of the accessories illustrated or
described are included as standard delivery.
Intended use
The machine is designed for grinding and
deburring metal using corundum grinding tools.
Noise vibration information
Measured values determined according to EN 50 144.
The A-weighted sound pressure level of the tool is
typically 82 dB (A).
The noise level when working can exceed 85 dB (A).
Wear ear protection!
The typical weighted acceleration is 3,5 m/s
2
For your safety
Working safety with this machine is
possible only when the operating and
safety information are read
completely and the instructions
contained therein are strictly followed. In
addition, the general safety instructions on
page 11 must be followed. Before using for the
first time, ask for a practical demonstration.
If the mains cable is damaged or cut
through while working, do not touch the
cable but immediately pull the mains plug.
Never use the machine with a damaged
cable.
Wear safety glasses.
Wear protective gloves and sturdy shoes.
When necessary, also wear an apron.
• Never allow children to use the machine.
• When working with the machine, always hold it
firmly with both hands and provide for a secure
stance.
• Always direct the cable to the rear away from the
machine.
• Always switch off the machine and allow to come
to a stop before placing it down.
• Insert the mains plug only when the machine is
switched off.
• Do not work with materials containing asbestos.
• Use only grinding tools with a permissible
allowable speed at least as high as the no-load
speed of the machine.
• Protect the grinding tool from impact, shock and
grease.
• Apply the machine to the workpiece only when
switched on.
• Keep hands away from rotating grinding tools.
• Pay attention to the direction of rotation. Always
hold the machine so that sparks and grinding dust
fly away from the body.
• When grinding metal, flying sparks are produced.
Take care that no persons are endangered. Due to
danger of fire, no combustible materials should be
located in the vicinity (spark flight zone).
GB
To Next Page
Loading...
Need help?
General