Bosch GLM 100 C User Manual

-38-
Cause
Battery charging voltage not
correct.
Corrective Measure
Check if the plug-in connection
has been established correctly and
if the battery charger is operating
properly
When the unit symbol is flashing,
the battery is defective and must
be consulted with Bosch after-
sales service.
Battery charge-control indicator (g), and “ERROR”
indication in the display
No Bluetooth ® connection
Cause
Failure of the
Bluetooth ®
connection.
Corrective Measure
Check the application on your
mobile terminal/device.
Check if
Bluetooth ® is activated
on your measuring tool and mobile
terminal/device.
Reduce the distance between
measuring tool and your mobile
terminal/device.
Data transmission via USB interface not possible
Cause
Software error
Corrective Measure
Make sure that the software runs
correctly on your computer or
notebook. For further information,
please refer to the Bosch website
at www.boschtools.com.
Cause
Micro USB cable
Corrective Measure
Check the proper and tight
connection of the micro USB cable
to the tool and/or computer or
notebook.
Check the micro USB cable for
damage.

Bosch GLM 100 C Specifications

General

Measurement Range	0.05 – 100 m
Accuracy	± 1.5 mm
Laser Class	2
Bluetooth	Yes
Dust and Water Protection	IP54
Laser Diode	635 nm, < 1 mW
Measurement Time, typical	0.5 s
Measurement Time, max.	4 s
Memory Capacity (Values)	50
Dimensions	111 x 51 x 30 mm
Automatic Deactivation	5 min
Weight, approx.	0.14 kg
Units of Measurement	m, in, ft
Data Transfer	Bluetooth
Storage Temperature	-20°C to +70°C