To Next PageTo Next Page
Need help?Do you have a question about the Bosch GLM 250 VF Professional and is the answer not in the manual?
General| Wavelength | 635 nm |
|---|---|
| Laser class | 2 |
| Measurement range | 0.05 - 250 m |
| Measurement accuracy | 0.001 m |
| Lowest indication unit | 0.05 mm |
| Tripod included | No |
| Battery type | LR03 (AAA) |
| Auto power off | Yes |
| Battery voltage | 1.5 V |
| Battery life (max) | 5 h |
| Number of batteries supported | 4 |
Weight and Dimensions| Weight | 240 g |
|---|---|
| Dimensions (WxDxH) | 66 x 120 x 37 mm |
Unfold the fold-out page for representation of the measuring tool.
Tool for measuring distances, lengths, heights, clearances, and calculating areas/volumes.
Explains the meaning of symbols and indicators shown on the device's display.
Instructions for inserting or replacing the battery in the measuring tool.
Guidelines for protecting the tool from environmental factors like moisture and temperature.
How to power the measuring tool on and off, and details on automatic power-off.
Step-by-step guide on how to perform measurements using the tool.
How to activate and use the continuous laser beam mode for consistent measurements.
Instructions on how to turn the display illumination on and off to conserve battery.
How to adjust and activate the audio signal for measurement confirmation.
Procedure to change the unit of measure displayed for measured values (e.g., meters, feet).
How to perform a basic length measurement using the tool.
How to perform continuous measurements where the value updates dynamically.
How to determine the shortest and longest distances from a reference point.
How to measure volumes by taking length, width, and height measurements.
How to measure distances indirectly when direct measurement is obstructed.
How to measure lengths indirectly using the Pythagorean theorem.
How to measure lengths indirectly using a double Pythagorean method.
How to measure lengths indirectly using a combined Pythagorean method.
How to measure lengths indirectly using a trapezium calculation method.
How to perform length measurements with a time delay for setup.
How to measure the sum of individual surfaces with a common height.
How to mark off a fixed length for layout or construction purposes.
How to recall and view the last 30 stored measurements and calculations.
How to delete individual or all stored measured values from the tool's memory.
General advice on handling the tool, covering lenses and movement.
Factors affecting the measuring range, like light and target surface.
How physical effects and surface types can impact measurement accuracy.
How to use the positioning pin for corner measurements or hard-to-reach areas.
How to use the spirit level for simple horizontal alignment of the tool.
How to use the optical sight for precise sighting over long distances.
How to use the alignment aid for sighting over larger distances.
How to use a tripod for measurements, especially at longer distances.
Corrective measures for when the tool is outside its operating temperature range.
Corrective measures when the battery voltage is low.
Corrective measures for when the battery voltage is too low to operate.
Troubleshooting for error messages related to measurement angles or conditions.
Troubleshooting for error messages related to calculation or unit mismatches.
Troubleshooting for inaccurate or implausible measurement results.
How to select the correct reference level for accurate measurements.
Ensure the laser point is completely on the target surface for accurate readings.
Instructions on how to properly clean and maintain the measuring tool.
Information on how to get help from Bosch customer service for repairs and spare parts.
Proper disposal guidelines for EC countries, avoiding household waste.
Guidelines for disposing of battery packs and batteries safely and environmentally.
