To Next PageTo Next Page
Need help?Do you have a question about the Bosch GLM 25 Professional and is the answer not in the manual?
General| Power Supply | 2 x 1.5 V LR03 (AAA) |
|---|---|
| Laser Diode | 635 nm, < 1 mW |
| Laser Class | Class 2 |
| Automatic Deactivation | after 5 minutes |
| Protection Class | IP 54 |
| Measuring Range | 0.05 - 25 m |
| Display | LCD |
| Units of Measurement | m, in, ft |
| Operating Temperature | -10 to +50 °C |
| Storage Temperature | -20 to +70 °C |
Read and observe all instructions for safe operation. Store instructions safely and never make warning signs unrecognizable.
Do not direct laser beam at persons/animals, avoid staring into beam, close eyes if exposed, no modifications.
Have repairs done by specialists. Do not allow children to use unsupervised. Avoid explosive environments.
The measuring tool is intended for measuring distances, lengths, heights, and clearances indoors.
Provides detailed specifications like article number and measuring range.
Lists and describes the numbered parts of the measuring tool (1-11).
Lists and describes the symbols and indicators on the display (a-e).
Instructions on how to insert and replace batteries, including polarity and battery status indicators.
Initial setup, precautions against moisture, temperature, and impact.
Procedures for turning the measuring tool and laser on and off.
How to perform a measurement using the tool, reference edge, and starting point.
Explains how the auto-sum feature calculates and displays the sum of multiple measurements.
Instructions on how to switch the unit of measure (e.g., meters to feet) using the button.
Details on how the display illumination works and dims to save battery.
Covers keeping the tool clean, not covering lenses, and not moving the tool during measurement.
Factors affecting measuring range like lighting and target surface reflectivity.
Lists surfaces and conditions that can lead to faulty measurements.
Method to verify the measuring tool's accuracy by checking a known distance.
Lists common issues like temperature warnings and error messages with their solutions.
Guidelines for keeping the tool clean, avoiding liquids, and maintaining the reception lens.
