14 | English
1 609 92A 3MW | (21.11.16) Bosch Power Tools
Avoid heavy impact to or falling down of the
measuring tool. After severe exterior effects to
the measuring tool, it is recommended to carry out
an accuracy check (see “Accuracy Check of the
Distance Measurement”, page 18) each time be-
fore continuing to work.
Switching On and Off
To switch on the measuring tool, briefly press the
measuring button 2. Measuring tool and laser are
switched on.
Do not leave the switched-on measuring tool
unattended and switch the measuring tool off
after use. Other persons could be blinded by the
laser beam.
To switch off the measuring tool, press the measur-
ing button 2 and hold it down.
Measuring Procedure (see figure A)
Once switched on, the measuring tool is in the length
measurement mode.
The rear edge of the measuring tool is always the ref-
erence level for the measurement.
Place the measuring tool against the desired starting
point of the measurement (e.g. a wall).
OBJ_BUCH-3062-001.book Page 14 Monday, November 21, 2016 4:09 PM
To Next Page
Loading...
