English | 15
Bosch Power Tools 1 609 92A 3MW | (21.11.16)
Briefly press the measuring button 2 to initiate the
measurement. Then the laser beam is switched off. To
switch the laser beam on again, briefly press the
measuring button 2. To initiate a further measure-
ment, briefly press the measuring button 2 again.
Do not point the laser beam at persons or ani-
mals and do not look into the laser beam your-
self, not even from a large distance.
Note: The measured value typically appears within
0.5 seconds and no later than 4 seconds. The dura-
tion of the measurement depends on the distance,
the lighting conditions and the reflective properties of
the target surface. Upon completion of the measure-
ment the laser beam is automatically switched off.
Auto-Sum (see figure B)
The auto-sum automatically shows the sum of all indi-
vidual measurements (e.g. useful for the material cal-
culation).
The auto-sum value is erased as soon as the device is
switched off or if it automatically switches off when no
button is pressed after 5 minutes.
The auto-sum is not saved. A subsequent correction
of the auto-sum is not possible.
Aim the laser beam at the target surface.
OBJ_BUCH-3062-001.book Page 15 Monday, November 21, 2016 4:09 PM
To Next Page
Loading...
