English | 17
Bosch Power Tools 1 609 92A 3MW | (21.11.16)
Display Illumination
The display illumination is continuously switched on.
When no button is pressed, the display illumination is
dimmed after approx. 10 seconds to preserve the
batteries/rechargeable batteries. When no button is
pressed for after approx. 30 seconds, the display illu-
mination goes out.
Working Advice
General Information
The reception lens 7 and the laser beam outlet 8 must
not be covered when taking a measurement.
The measuring tool must not be moved while taking a
measurement. Therefore, place the measuring tool,
as far as this is possible, against or on a firm stop or
supporting surface.
Influence Effects on the Measuring Range
The measuring range depends on the lighting condi-
tions and the reflective properties of the target sur-
face. For better visibility of the laser beam in extrane-
ous light, use the laser viewing glasses 10
(accessories) and the laser target plate 9 (accesso-
ries) or shade the target area.
OBJ_BUCH-3062-001.book Page 17 Monday, November 21, 2016 4:09 PM
To Next Page
Loading...
