8 | English
1 609 929 R77 | (24.2.09) Bosch Power Tools
f Hold the power tool only by the insulated
gripping surfaces when performing an oper-
ation where the cutting tool may contact
hidden wiring or its own cord. Contact with
a “live” wire will also make exposed metal
parts of the power tool “live” and shock the
operator.
f When working with the machine, always
hold it firmly with both hands and provide
for a secure stance. The power tool is guided
more secure with both hands.
f Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held
more secure than by hand.
f Keep your workplace clean. Blends of mate-
rials are particularly dangerous. Dust from
light alloys can burn or explode.
f Always wait until the machine has come to
a complete stop before placing it down. The
tool insert can jam and lead to loss of control
over the power tool.
f Never use the machine with a damaged ca-
ble. Do not touch the damaged cable and
pull the mains plug when the cable is dam-
aged while working. Damaged cables in-
crease the risk of an electric shock.
Functional Description
Read all safety warnings and all in-
structions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
Intended Use
The machine is intended for sawing wood, plas-
tic, metal and building materials while resting
firmly on the workpiece. It is suitable for
straight and curved cuts. When using the appro-
priate bimetal saw blades, it is possible to cut
flush to the workpiece surface. The saw blade
recommendations must be observed.
Product Features
The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 Saw blade*
2 Adjustable footplate
3 Saw blade holder
4 Stroke rod
5 SDS clamping lever for saw blade release
6 Utility hook
7 Lock-off button for On/Off switch
8 On/Off switch
9 Allen key
10 “Power Light”
11 Clamping plate
12 Screws for footplate adjustment
*Accessories shown or described are not part of the
standard delivery scope of the product. A complete
overview of accessories can be found in our acces-
sories program.
Technical Data
Sabre saw GSA 1100 E
Professional
Article number
3 601 F4C 8..
Rated power input
W1100
Stroke rate at no load n
0
min
-1
0–2700
Tool holder
SDS
Stroke rate control
z
Stroke
mm 28
Cutting capacity, max.
–in wood
– in non-alloy steel
– Pipe diameter
mm
mm
mm
230
20
150
Weight according to
EPTA-Procedure 01/2003
kg 3.5
Protection class
/II
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltage and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.
OBJ_BUCH-829-004.book Page 8 Tuesday, February 24, 2009 9:04 AM
To Next Page
Loading...
