English–3
1 619 929 697 • 14.2.06
Technical Data
Product Features
The numbering of the product features refers to the
illustration of the machine on the graphics page.
1 Dust protection cap
2 Locking sleeve
3 Chisel adjustment ring (Vario-lock)
4 On/Off switch
5 Thumbwheel for preselection of impact rate
6 Service indicator
7 Auxiliary handle
8 Knurled nut for auxiliary handle
Not all of the accessories illustrated or described are
included as standard delivery.
Noise/Vibration Information
Measured values determined according to EN 60745.
Typically the A-weighted noise level of the machine is:
sound pressure level 89 dB(A); sound power level
100 dB(A). Uncertainty K=3 dB.
Wear hearing protection!
Overall vibrational values (vector sum of three direc-
tions) determined according to EN 60745:
Chiselling: Vibration emission value a
h
=16 m/s
2
,
uncertainty K=2 m/s
2
.
The vibration emission level given in
this information sheet has been meas-
ured in accordance with a standardised test given in
EN 60745 and may be used to compare one tool with
another.
The vibration emission level will vary because of the
ways in which a power tool can be used and may
increase above the level given in this information sheet.
This could lead to a significant underestimate of expo-
sure when the tool is used regularly in such a way.
Note: To be accurate, an estimation of the level of
exposure to vibration experienced during a given period
of work should also take into account the times when
the tool is switched off and when it is running but not
actually doing the job. This may significantly reduce the
exposure level over the total working period.
Declaration of Conformity
We declare under our sole responsibility that this prod-
uct is in conformity with the following standards or
standardization documents: EN 60745 according to
the provisions of the directives 89/336/EWG,
98/37/EG, 2000/14/EG.
2000/14/EG: The guaranteed sound power level L
WA
is below 105 dB(A). The valuation procedure for the
conformity is in accordance with appendix VI.
Designated testing authority:
TÜV NORD CERT GmbH & Co. KG,
Am TÜV 1, 30519 Hannover
Leinfelden, 01.12.2005
Robert Bosch GmbH, Power Tools Division
Assembly
Auxiliary Handle
Operate your machine only with the auxiliary
handle 7.
The auxiliary handle 7 can be set to any position for a
secure and low-fatigue working posture.
Loosen the knurled nut 8, rotate the auxiliary handle 7
around the axis of the machine to the required position
and tighten the knurled nut 8 again.
Demolition Hammer GSH 11 E
PROFESSIONAL
Article number 0 611 316 7..
Rated power input W 1500
Impact rate bpm 900–1890
Impact energy per stroke J 6–25
Chisel positions 12
Chiselling capacity in
concrete of medium
hardness kg/h 490
Tool holder SDS-max
Lubrication Central permanent
lubrication
Weight according to
EPTA-Procedure
01/2003
kg 10.1
Protection class
/II
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltage and models for specific coun-
tries, these values can vary.
Please observe the article number on the type plate of your
machine. The trade names of the individual machines may
vary.
Dr. Egbert Schneider
Senior Vice President
Engineering
Dr. Eckerhard Strötgen
Head of Product
Certification
WARNING
OBJ_BUCH-1 619 929 697-003.book Page 3 Tuesday, February 14, 2006 3:05 PM
To Next Page
Loading...
