To Next PageTo Next Page
Need help?Do you have a question about the Bosch GSR 12V-15 FC and is the answer not in the manual?
General| Battery Voltage | 12V |
|---|---|
| Max Torque | 30 Nm |
| Max Torque Soft Joint | 15 Nm |
| Max Drilling Diameter in Wood | 30 mm |
| Max Drilling Diameter in Steel | 10 mm |
| Length | 132 mm |
| Battery Type | Li-ion |
| Chuck Type | Keyless |
| Weight Including Battery | 0.8 kg |
| No-load Speed | 0 – 400 / 0 – 1, 300 rpm |
Read all safety warnings and instructions. Failure to follow may result in injury.
Keep work area clean, well lit, and free from flammable materials.
Ensure proper grounding and avoid contact with earthed surfaces.
Stay alert, use common sense, wear protective equipment, avoid distractions.
Use correct tool, maintain it, keep cutting tools sharp, and store properly.
Use correct charger/battery, avoid heat, and handle with care to prevent damage.
Have power tools serviced by qualified personnel using identical replacement parts.
Hold by insulated surfaces, prevent unintentional starting, secure workpiece.
Use appropriate speed, start slow, apply pressure in line with bit, avoid overreaching.
Secure workpiece, wait for stop, switch off if blocked, check for hidden lines.
Power tool for driving screws and drilling in wood, metal, and plastic.
Lists numbered features of the power tool and its accessories.
Provides technical specifications for the power tool and adapters.
Wear hearing protection. Vibration values determined according to EN 62841.
Insert charged battery into handle until it engages.
Change rotational direction using switch (6) only when tool is off.
Use torque presetting ring to select torque in 15 stages for controlled screwdriving.
Select between two speed ranges (Gear I/II) for screwdriving or drilling.
Press on/off switch to start/stop. Worklight illuminates work area.
Adjust rotational speed by varying pressure on the on/off switch.
Spindle locks when switch is not pressed, allowing use as screwdriver.
Tool reduces output or switches off if overloaded or outside temperature range.
Shows battery charge level using three green LEDs when switch is pressed.
Advice on tool usage, cooling down, drilling into metal, and pre-drilling screws.
Remove battery before maintenance. Keep tool and ventilation slots clean.
Contact service for questions on maintenance, repair, spare parts, and application advice.
Lithium-ion batteries subject to dangerous goods legislation for transport.
Dispose of power tools, batteries, accessories environmentally friendly.
