Bosch GSR 14,4 VE-2 Professional - Declaration of Conformity

English | 21
Bosch Power Tools 1 609 929 M31 | (11.9.07)
Declaration of Conformity
We declare under our sole responsibility that the
product described under “Technical Data” is in
conformity with the following standards or
standardization documents: EN 60745 according
to the provisions of the directives 2004/108/EC,
98/37/EC (until Dec. 28, 2009), 2006/42/EC
(from Dec. 29, 2009 on).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
16.07.2007, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Noise/Vibration Information
Measured values determined according to
EN 60745.
GSR 12 VE-2/GSR 14,4 VE-2/GSR 18 VE-2/
GSR 24 VE-2:
Typically the A-weighted sound pressure level of
the product is less than 70 dB(A). The noise level
when working can exceed 80 dB(A).
Wear hearing protection!
Vibration total values (triax vector sum) deter-
mined according to EN 60745:
Drilling into metal: Vibration emission value
a
h
< 2.5 m/s
2
, Uncertainty K =1.5 m/s
2
,
Screwdriving: Vibration emission value
a
h
< 2.5 m/s
2
, Uncertainty K=1.5 m/s
2
.
Combination Cordless Drill GSB 12 VE-2
Professional
GSB 14,4 VE-2
Professional
GSB 18 VE-2
Professional
GSB 24 VE-2
Professional
Article number
0 601 913 5.. 0 601 913 4.. 0 601 913 3.. 0 601 913 2..
Rated voltage
V= 12 14.4 18 24
No-load speed
– 1st gear
– 2nd gear
rpm
rpm
0–500
0–1700
0–500
0–1750
0–500
0–1800
0–500
0–1800
Impact rate
spm 0–21000 0–21000 0–21000 0–21000
Torque adjustment range
Nm 1.5–9 1.5–91.5–9 1.5–9
Max. torque for hard/soft
screwdriving application
according to ISO 5393
Nm 60/22 65/24 70/28 75/34
Max. drilling dia.
– Steel
–Wood
– Brickwork
mm
mm
mm
13
30
10
13
32
12
13
35
14
16
38
16
Max. screw dia.
mm 8 81012
Chuck clamping range
mm 1.5–13 1.5–13 1.5–13 1.5–13
Drill spindle thread
1/2" 1/2" 1/2" 1/2"
Weight according to
EPTA-Procedure 01/2003
kg 2.6 2.7 3.0 3.2
Please observe the article number on the type plate of your machine. The trade names of the individual machines may
vary.
Dr. Egbert Schneider
Senior Vice President
Engineering
Dr. Eckerhard Strötgen
Head of Product
Certification
OBJ_BUCH-483-001.book Page 21 Tuesday, September 11, 2007 8:18 AM