English | 9
Bosch Power Tools 1 609 929 M81 | (3.12.07)
Technical Data
Assembly
Battery Charging
A new battery or a battery that has not been used
for a longer time produces full power only after
approximately five charge/discharge cycles.
To remove the battery 6, press the unlocking but-
tons 7 and pull out the battery downwards. Do
not exert any force.
The battery is equipped with an NTC tempera-
ture control which allows charging only within a
temperature range of between 0 °C and 45 °C. A
long battery service life is achieved in this man-
ner.
A significantly reduced working period after
charging indicates that the battery is used and
must be replaced.
Observe the notes for disposal.
Changing the Tool (see figure A)
f Before any work on the power tool (e. g.,
maintenance, tool change, etc.) as well as
during transport and storage, set the rota-
tional direction switch to the center posi-
tion. Unintentional actuation of the On/Off
switch can lead to injuries.
Hold the rear sleeve 3 of the keyless chuck 1
tightly and turn the front sleeve 2 in rotation di-
rection n, until the tool can be inserted. Insert
the tool.
Hold the rear sleeve 3 of the keyless chuck 1 tight
and firmly turn the front sleeve 2 in rotation di-
rection o by hand.
The locking is released again to remove the tool
when the front sleeve 2 is turned in the opposite
direction.
Cordless Screwdriver GSR 9,6-2
Professional
GSR 12-2
Professional
GSR 14,4-2
Professional
Article number
3 601 J18 L.. 3 601 J18 J.. 3 601 J18 G..
Rated voltage
V= 9.6 12 14.4
No-load speed
– 1st gear
– 2nd gear
rpm
rpm
0–400
0
–1000
0–400
0
–1200
0
–400
0
–1400
Max. torque for hard/soft screwdriving
application according to ISO 5393
Nm 25/10 27/11 30/15
Maximum drilling diameter
(1st/2nd gear)
– Steel
–Wood
mm
mm
10/10
20/13
12/12
23/14
12/12
26/19
Max. screw dia.
mm 6 78
Chuck clamping range
mm 1–10 1–10 1–10
Drill spindle thread
3/8" 3/8" 3/8"
Weight according to EPTA-Procedure
01/2003
kg 1.5 1.6 1.7
Please observe the article number on the type plate of your power tool. The trade names of individual tools may vary.
OBJ_BUCH-593-001.book Page 9 Monday, December 3, 2007 3:49 PM
To Next Page
Loading...
