To Next PageTo Next Page
Need help?Do you have a question about the Bosch GST 500 PE and is the answer not in the manual?
General| Power Input | 500 W |
|---|---|
| Stroke Rate | 500 - 3100 spm |
| Cutting Depth in Steel | 6 mm |
| Cutting Depth in Aluminium | 20 mm |
| No-load Speed | 500 - 3100 rpm |
| Stroke Length | 20 mm |
Keep work area clean and well lit. Cluttered or dark areas invite accidents.
Power tool plugs must match the outlet. Never modify the plug in any way.
Stay alert, watch what you are doing and use common sense when operating a power tool.
Do not force the power tool. Use the correct power tool for your application.
Have your power tool serviced by a qualified repair person using only identical replacement parts.
Before any work on the machine itself, pull the mains plug.
Before any work on the machine itself, pull the mains plug.
The four orbital action settings allow for optimal adaptation of cutting speed.
The base plate can be swivelled by 45° to the left or right for mitre cuts.
For sawing close to edges, the base plate can be offset to the rear.
With the air jet of the sawdust blower device, the cutting line can be kept free of dust.
The contact protector attached to the casing prevents accidental touching of the saw blade.
Observe correct mains voltage! The voltage of the power source must agree with the voltage specified.
To start the power tool, push the On/Off switch forwards. To switch off, push it towards the rear.
With the thumbwheel for stroke rate preselection, the stroke rate can be preset.
When working small or thin work pieces, always use a sturdy support or a saw table.
The plunge cutting procedure is only suitable for treating soft materials.
Before any work on the machine itself, pull the mains plug. Keep machine and ventilation slots clean.
